Dotco 14CFS93-98 Manuale delle parti - Pagina 6

Sfoglia online o scarica il pdf Manuale delle parti per Utensile elettrico Dotco 14CFS93-98. Dotco 14CFS93-98 8. 14cf series, shears & scissors

PL31-14CF-1

September 11, 2002

3. Begin tightening rotor nut without over tightening to avoid

damaging the ball bearing. Alternately spin the rotor while

tightening until clearance is judged to be proper - about

0.001" clearance.

a. One method, shown at right, is to use a piece of

pipe which is slightly longer than the rotor, and tap

lightly against a work bench several times. This

helps seat threaded components.

b. A second method is to hold the rotor rear plate

assembly vertically (plate downward) and lightly

strike the edge of the plate with a wood block,

alternating sides.

PARTS INSPECTION

1. Wash all parts except ball bearings in solvent. Dry

and place on a clean cloth for inspection.

2. Check ball bearings for wear. Bearings should turn

smoothly with no appreciable shake or looseness.

14CFS93-98 Scissors & 14CFS93-99 Shears

DOTCO

HARDWOOD

BLOCK

3. Check rotor blades for wear by comparing with a new

blade. Replace if worn more than 1/32" in height.

4. Check motor cylinder for grooves, gouges or pitting.

Honing is permissible, however, never remove more than

about 0.001" or 0.002" of material. Replacement is

usually recommended.

Page 6

0.001"

CLEARANCE

ROTOR

PIPE OR

SPACER

FLAT SURFACE