Advance Power 16004-8 Installazione manuale - Pagina 7

Sfoglia online o scarica il pdf Installazione manuale per Riscaldatore per piscina Advance Power 16004-8. Advance Power 16004-8 9. Api poly pro solar collector swimming pool solar heating systems

Stampa la pagina

7. Proceed to the lower chalk lines previously snapped

on the roof for the strap hold-down brackets. Mark a

hole 2" to the side of the first panel and continue

marking holes on the chalk line centered exactly

between the absorber surfaces until you reach the last

collector. Mark the last hole the same 2" to the side of

the last panel. Drill a pilot hole and apply roof sealant

at each of these locations. Bolt the strap hold-down

brackets on the roof. Refer to Figure 9. It is OK to

step on the collectors as long as you stay one foot

away from the top and bottom headers.

8. Slip one end of a hold-down strap through the slots

in the strap hold-down bracket at the end of the row.

Pull about 9" of the strap through and slip the loose

end of the strap through the slot closer to the collector

and pull it tight and tie a double knot. Refer to Figure

10.

9. Bring the remaining strap end across the panel face,

passing through both slots in the bracket located on

the other side of the panels. Pull the straps taut against

the face of the panel. Repeat this procedure for the

remaining hold-down strap. Refer to Figure 11.

10. Secure opposite end of strap as shown in Figure

Repeat this procedure for the center and the bottom

straps.

11. Install the vacuum relief valve in the outlet header

of each row. This will be located at the opposite end

of the row that is connected to the collector outlet

pipe. Refer to Figures 4 and 12.

12. Install an end cap in the inlet header of each row,

opposite the end that is connected to the collector inlet

pipe. Refer to Figures 4 through 12.

13.

INSPECT THE INSTALLATION AND CHECK

ALL CLAMPS FOR PROPER POSITION AND

TIGHTNESS.

14.

FOR HURRICANE OR HIGH WIND AREAS,

USE HURRICANE PANEL HOLD-DOWN KIT, Part

No.

18006.

CONTACT

INSTALLATION INSTRUCTIONS.

Refer to the 'System Diagram' Figure 12, throughout

this section. The most common piping configurations

use a pressure filter. The pump draws the water from

the skimmer and/or a main drain, forcing it through

the filter and sending back to the pool through the

return lines.

If a fuel-fired heater is installed, it is located between

the filter and the return line to the pool. The pipes to

and from the solar collectors are connected to the

return line to the pool before the water enters the fuel-

fired heater, if one is used.

Whenever there is more than 40 gpm required flow

rate to the collectors or more than 100 feet of piping

used in a system, install 2" piping to and from the

panels. Piping to and from the collectors shouldbe the

same type of plastic piping and fittings approved for

use with summing pool filters and pumps. It is

recommended to always user Schedule 40 PVC pipe

and fittings.

FACTOR

FOR