1byone 1-AD07US01 Manuale di istruzioni - Pagina 10
Sfoglia online o scarica il pdf Manuale di istruzioni per Giradischi 1byone 1-AD07US01. 1byone 1-AD07US01 11.
7. Tighten the screws completely once the perfect alignment is achieved.
NOTE: If you are unfamiliar or uncomfortable with completing this procedure, we
recommend consulting with a professional to perform the installation.
Technical Specifications
Turntable
Model
1-AD07US01,H005
Nominal Speeds
33 1/3 & 45RPM
Effective Tonearm Length 8.6" (218.5mm)
Tracking Force Range
3.0-6.0g
Outboard Power Supply
12V/ 500mA AC-DC
AC Power Adapter
Input: 100-240V 50/60Hz, Max. 200mA
Dimensions (W x H x D)
16.34" x 10.2" x 4.44" (415 x 340 x 148mm)
Weight
13.67lbs (6.2kg)
Cartridge
Stylus Model
Frequency Response
Recommended Load Resistance
Channel Balance
Amplifier Connection
Channel Separation
Recommended Tracking Force
Output Voltage
Weight
Potential Incorrect Use and Fault Conditions
This turntable is manufactured to the highest standards and undergoes strict quality
controls before leaving the factory. Faults that may possibly occur are not necessarily
due to material or production faults but can sometimes be caused by incorrect use or
unfortunate circumstances. Therefore the following list of common fault symptoms
has been included here.
Speed Variance
Wow and Flutter
Signal to Noise
Overhang
Power Consumption 5W
Audio Technica AT-3600L
20Hz-20kHz
47kohms
< 2.5dB
MM - input
> 18dB
3.5±0.5g
2.5mV
5g
16
There is no power:
- The turntable is not connected to the power adapter.
- No power at the outlet.
The platter doesn't turn although the unit is switched on:
- The unit is not connected to the main power supply.
- No power at the outlet.
±1.5%
- Drive belt is not installed or has slipped off.
≤0.15%
55dB
No signal through one or both channels:
0.73in
- Phono input not selected on amplifier.
- Amplifier not switched on.
- Amplifier or speakers muted.
- No connection to the speakers.
- No connection between turntable and amplifier.
- Wire leads not connected the cartridge.
Strong hum on phono input:
- No ground connection from cartridge, arm, or arm cable to amplifier or ground loop.
- Turntable is too close to speakers.
Distorted or inconsistent sound from one or both channels:
- Turntable is connected to wrong input of the amplifier.
- Needle or cantilever damaged.
- Drive belt overstretched or dirty.
- Platter bearing without oil, dirty or damaged.
- Dust on stylus.
- MM / MC switch on pre-amplifier set incorrectly.
Cannot connect with Bluetooth speaker:
- The turntable is not in pairing mode.
- Your Bluetooth speaker is not in pairing mode.
- The Bluetooth transmitter has turned off because Bluetooth is not connected in 2
minutes.
17