Electra Light RGB 10W – Di-PA Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzature per DJ Electra Light RGB 10W – Di-PA. Electra Light RGB 10W – Di-PA 4. Laser show system

Stampa la pagina

Function Setting （Digital board）

THE 'MODE' FUNCTION

'Audi': Sound control

'Auto': Auto-run control

'dxxx': DMX512 control

The 'xxx' is address code. Press 'UP' or 'DOWN' to set it down.

'SLAV': Slave machine

In this mode, the salve machine will do the same effect as master

machine.

'XXXX': TOTAL RUNING TIME

In this mode, you can know how long the laser has worked.

'ENTER': Press ENTER after setting is done.

Installation

1、Firstly, be sure that the using voltage is match with the voltage

marked on the base of the laser lighting;

2、Installation should be made by professional technician. Fix the laser

lighting and adjust the angle of the laser lighting to you need;

3、Please check whether the fan and the exhaust is blocked;

4、There is a hole for connection. When hang the laser lighting, be sure

the cable can undertake 10 times of the lighting weight;

5、The laser lighting should be fixed;

6、It is essential to be earthed well for the sake of safety.

----------------- 2 -------------------

DMX512

This laser light is controlled by the standard DMX. Please

connect controlling panel with the lighting as following

Before using the DMX512 controller, you should set the

channel address in the digital display.

One unit has 9 channels, so each unit must be assigns 9 channels

at least. We may assign 9 channels for one unit, then DMX

address = 12*N+1, N=0, 1, 2, 3 ......

Example: One loop address=1, two loop address=13, three loop

address=25, four loop address=37

Loop

PC Control

If it is set to ILDA mode (use PC software to control light), just

need to connect ILDA signal to DB25 jack. ILDA mode ( PC

control) and built-in program mode can be identified and transited

automatically.

-----------------3-------------------

Digital address