Douglas D-Pro Max Series Istruzioni di montaggio e manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Istruzioni di montaggio e manuale d'uso per Accessories Douglas D-Pro Max Series. Douglas D-Pro Max Series 8. Adjustable basketball system

Stampa la pagina

STEP 6

Crank the Main extension arm as low as possible.

Attach the Backboard to Main Extension Arm (F) by

using two Hex Bolt M12 x 1.57" (#4), four M12 Flat

Washers(#13), two Nylon washers (#3) and one Lock Nut

M12 (#16).

Note: Nylon washers go between Main extension arm Bracket

(F) and Backboard mounting bracket.

Connect Upper Extension Arms (G) to Backboard

(H), using 2 Hex bolts M12 x 1.37" (#10), 4 Flat

Washers M12 (#13), 2 Nylon washers M12 (#3) and

2 Lock nuts M12 (#16).

Note: Put Nylon washers between backboard plate and

Upper extension connecting plate.

STEP 8

A. After everything is square, make sure all nuts on the

system have been tightened.

NOTE: But do not over tighten the Nuts, make sure the unit

can be adjusted up and down.

B. To apply the Rim Height Sticker(In the manual pack), first use

a tape measure to crank rim up to exactly 10' from the playing

surface. Use a pencil to make a mark on the Spring-assist

Cartridge(C) where the bottom of the Rim Height Indicator(K)

stops. Then, peel and apply Rim Height Sticker to outside

of Spring-assist Cartridge(C) lining up the pencil mark with the

10' mark on the Rim Height Sticker. See detail A.

C. Attach Post Pad and Gusset Pad to Main Post(A) as shown.

STEP 7

Remove the screws on Rim spring box cover, open the Spring

box.

(Rim Spring Box cover may not be factory-assembled.)

Mount the rim to the Mounting bracket on Backboard (H)

using the hardware supplied in rim box.

Re-attach Spring box cover to the Rim with removed screws.

NOTE: Use a level to make sure rim is level side to side

before tightening nuts.

R2 R3

DETAIL A

Rim Height

Sticker