Comanche BITS Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Strumenti Comanche BITS. Comanche BITS 6. Bungee installation tool system

3. Place the inboard end of the bungee over the fixed

bungee post of the stretching tool, seating the bungee

into the groove on the post as you expand the stretcher

tool. See next step.

4. Using a suitable tool (a socket wrench, an electric

drill, an impact wrench with a ¾" adaptor, or an open

end/box end wrench, etc), screw the hex drive counter-

clockwise (as viewed from the hex nut end) until the

bungee is stretched about 1½ to 2 inches past the

inboard saddle flanges. Don't extend the tool any

more than necessary. Now you can easily remove the

detent ring pin and collapse the installer tool. This will

make it easy to remove the tool itself from between

the bungee halves.

5. Screw the hex drive clockwise to retract the outboard

tool arm until the bungee is loose on the fixed bungee

post.

6. While leaving the pulley bracket bolted in the

outboard arm, remove the cotter key from the pulley

clevis pin and pull out the clevis pin that will free the

pulley from the bracket. Remove the old bungee cord

and replace it with a new one. Assemble the pulley

and clevis pin back into the bracket in reverse order

and insert a new cotter key into the clevis pin.

7. Place the other end of the bungee cord over the tool's

fixed post and screw the hex drive counterclockwise

until the bungee is stretched enough to insert the

installer tool. Insert the installer tool between the

bungee cord halves in the same manner as you did in

the plane, i.e., by removing the detent ring pin,

collapsing the installer tool, and inserting it between