Douglas Dynamics SnowEx Brine Pro 2000 Manuale - Pagina 6
Sfoglia online o scarica il pdf Manuale per Pompa dell'acqua Douglas Dynamics SnowEx Brine Pro 2000. Douglas Dynamics SnowEx Brine Pro 2000 10. Gas engine transfer pump, brine maker
Stampa la paginaTPS-200
9. Polish the drive unit shaft to remove any corrosion
that may have formed. Clean the engine mounting
surface of any debris, and polish if necessary.
Clean the
engine
mounting
surface.
Polish the
drive unit shaft.
Assembly Instructions
1. Install the pump slinger on the drive unit shaft. The
slinger should be slid all the way back on the shaft
of the drive unit so that the slinger covers the step
on the drive unit shaft as shown.
Lit. No. 11814, Rev. 00
2. Place the seal O-ring behind the lip of the spring
half of the seal assembly. Install the seal assembly
half into the rear bracket using a tool such as
a 1-1/2" pipe nipple or arbor press to give even
pressure on the metal fl ange of the seal housing
during installation. Gently press the seal into
position until it bottoms.
3. Place a fl at washer and screw head O-ring on
each of the four 5/16" x 1-3/4" cap screws. Install
the rear bracket onto the engine using the bracket
screw assemblies from the previous step. The
handle of the rear bracket should be to the top of
the drive unit. Tighten securely.
6
Rear
Bracket
Screw-Head
O-Rings
Flat
Washers
5/16" x 1-3/4"
Cap Screws
October 1, 2017