Douglas Dynamics SnowEx Brine Pro 2000 Manuale - Pagina 9

Sfoglia online o scarica il pdf Manuale per Pompa dell'acqua Douglas Dynamics SnowEx Brine Pro 2000. Douglas Dynamics SnowEx Brine Pro 2000 10. Gas engine transfer pump, brine maker

Stampa la pagina

Pump Priming

NOTE: Running the pump with no liquid will cause

damage. Make sure the pump is primed before

operation.

Make sure the circulation pump is appropriately

primed every time the unit is started. If the pump

does not automatically prime within 20 seconds of the

circulation pump starting (no visible churn in the liquid

being pumped), stop the unit and manually prime the

pump following the instructions below.

Manual Pump Priming

1. Remove the pump plug and ﬁ ll the chamber with

at least 64 oz of water or brine.

Pump

Plug

2. Replace the plug and jog the pump for a few

seconds to remove any air in the circulation

system.

3. Repeat Steps 1 and 2 until the pump is primed.

The liquid in the mixing tank will begin to

noticeably churn once the pump is primed.

Lit. No. 11814, Rev. 00

Maintenance and Storage

• There is no need to lubricate the pump. The seal is

lubricated and cooled by the ﬂ uid that is pumped.

• Drain the pump body after use if there is a danger

of freezing.

• If the engine will be unused for long periods of

time, drain the pump, leave the ﬁ ll and drain plugs

out of the pump, and store the unit in a heated, dry

building.

• See the engine manual for further instructions.

TPS-200

October 1, 2017