Asus RT-N16 Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Router wireless Asus RT-N16. Asus RT-N16 9.

♦

Admin page: Reset with Restore Factory Default settings and let the router reboot. NOTE this

may soft brick it! To be absolutely sure this does not happen you can login to the router and

issue the mtd commands listed above and start over with the K6 trailed build on recovery

mode followed by the special transition build.

Open the DD-WRT's web interface in your web browser. Upload/upgrade the firmware using the

Administration tab -> "Firmware Upgrade" button.

Click "browse" button and select the downloaded file then click "Upgrade". Wait 5 minutes to upload

and write the flash, then the browser GUI should refresh when done.

♦

Admin page: Reset with Restore Factory Default settings. (Only necessary if coming from an

old build)

♦

Alternative: on the Upgrade page, select "Reset to Default settings" for "After flashing, reset

to". This is to automatically reset to Factory Default settings when it reboots, though this may

not be reliable.

Note: For newer builds, please read the "New Build" or router-specific threads. See Where do I

•

download firmware for more info on New build threads.

Restore to Asus Firmware

Download the latest ASUS firmware from the ASUS web site [5]. Or use FTP.

Rename the Asus firmware file from .trx to .bin

Do a Restore Factory Default settings to Clear NVRAM in DD-WRT

Go to the DD-WRT firmware upgrade page and select the renamed ASUS firmware

After the flash finishes, and the router has rebooted, you see the ASUS GUI. If not, clear browser

cache.

Do a Factory Reset to clear the NVRAM using the Asus GUI

To access recovery mode, you MAY have to press the WPS button (not the reset button like other ASUS),

then plug in power, and tftp the firmware you want to flash. Some people have reported that the reset button

DOES work like the other ASUS routers to get it into recover mode. GUI Factory Reset before and after every

flash to make sure you don't have any nvram problems or conflicts. On this router, the reset button only resets

the nvram partition.

Hard reset to factory defaults by holding in the red WPS button while plugging in the power. Eko

Forum note

Recovery mode, to upload a different firmware.

Internal serial connector, using CFE commands. Use 3.3V TTL level signaling. For example: US shop

FTDI Serial Adapter is small and reliable, providing: Virtual serial port via PC USB to 3.3V-TTL

(Rx, Tx) signaling. UK outlet

Try to reset/reload the firmware using the TJTAG software and the internal JTAG connector.

Restore to Asus Firmware

Asus_RT-N16