Dove Lighting Systems DimmerMaster Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Dimmer Dove Lighting Systems DimmerMaster. Dove Lighting Systems DimmerMaster 12. Wall mount dimmer packs

Stampa la pagina

channels should not overlap channels for other DMX equipment, including strobe lights, & fog

machines. It is not necessary to set the starting channels in sequence (ie. 1-4, 5-8, 9-12).

The Wall Mount DimmerMasters have a heat-shrink guard around the thumbwheel switch.

While this can make it a little more challenging to manipulate the buttons, it generally

prevents the settings from being inadvertently changed by bumping into wires as the unit is

installed in the electrical box enclosure after conﬁguration — a far more frustrating issue to

troubleshoot.

The thumbwheel switch enables the load testing / local control functions. The load test is

useful for determining which load is plugged in. Set the ﬁrst digit to 6 and the second digit to

the dimming channel (from 1 to 4, but only 1 on the DM124). Set the third digit to the dimming

level, from 0 (off) to 9 (full on). Levels thus set remain in effect until the power is disconnected

or control is returned to DMX.

Here is an example:

•

Set the thumbwheel switch to 600 for local control.

•

Set the second digit to 1 to control the lamp on channel one. Set the third digit to 5 to put

lamp one at half power. (The ﬁrst load will now stay at half power)

•

Next, set the second load to half power by setting the thumbwheel to 625. (The ﬁrst and

second load are now both at half power)

•

Finally, set the thumbwheel to 639. This will set the third load to full on while leaving the

ﬁrst two loads at half power.

A Crossfade Chase function is also available for stand alone operation without a DMX

source. Set the thumbwheel switch to 701 through 799 and the unit will perform a crossfading

chase with 1 (701) to 99 second (799) steps between each of the four channels. On the

single channel DM124, the chase function only fades the channel up and down with a 50%

duty cycle.

Example: 

Thumbwheel switch is set to 710. The unit will then crossfade from channel #1 to channel #2

in 10 seconds. Then the unit will crossfade from channel #2 to channel #3 in ten seconds,

from channel #3 to channel #4 in ten seconds, and then back to channel #1. This will repeat

until you change the thumbwheel setting or power down the unit.

To return to DMX operation, set the thumbwheel switch to the DMX start channel of your

choice (1-512).

WALL MOUNT SHOEBOX - USER MANUAL

Load Test & Local Control