Amphenol AMPHE-EX L-2124 Manuale di istruzioni per il montaggio - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Cavi e connettori Amphenol AMPHE-EX L-2124. Amphenol AMPHE-EX L-2124 17.

Slide securing devices forward and tighten using connector pliers. Connector holding tools are

recommended while tightening back accessories.

Soldering is the process in which two or more products are joined together by melting and flowing a filler (solder) into the

joint, adhering to the standards specified in IPC/WHMA-A-620B. The filter (solder) having a lower melting point than the

adjoining metals(s).

Measure and remove outer jacket per drawing specifications, using cable strippers.

Plug in the iron and turn it on. Soak sponge with water, sponge is used to clean the

solder off the tip of soldering iron. Adjust the temperature on the iron dial to 750

degrees (75 on dial). Once the Iron is hot, wipe both sides of the soldering tip on

Holding the solder (lead free) in one hand and the iron in the other, briefly touch

Now that the tip is properly tinned and the cable wire is prepared. Hold your iron

contact, heat the sides to allow solder to flow to the bottom of the contact. Insert

cable wire into contact once solder melts. It is important that you hold everything

Soldering Work Instructions

Step 1 : Prepping Cable (Strip Cable Insulation)

Avoid cable damage by stripping slightly smaller than the wire diameter. After

cable has been stripped, dip the end of the cable wire in flux (lead free).

Step 2 : Prepping the Iron (Cleaning the Tip)

the sponge. This will remove old solder from the tip.

"Tinning", when you put a light layer of solder over another piece of metal.

the solder to both sides of the tip. "Tinning" improves conductivity and make

soldering easier, as well as quicker.

and solder on opposite sides of the cable wire. Apply solder (lead free) into

very steady until solder begins to flow. After soldering one or two connections,

clean and re-tin the tip. Soldering must be done quickly, since you can melt the

cable insulation. Apply heat shrink on every single conductor to prevent solder

Step 3 : Tin the Tip

Step 4 : Applying the Solder

bridges between contacts.

Page 8 of 17