Comat SMS Relay Manuale di istruzioni per l'uso - Pagina 12
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Telecomando Comat SMS Relay. Comat SMS Relay 17. Message system
Stampa la paginaComat SMS Relay
The receiver of the status messages can now be chosen from the telephone book. In order to
do this click with the mouse pointer on the expand arrow and select the required entry.
6.5
Status messages
The SMS relay can send the following status messages:
•
Remote enquiry of all inputs and outputs
The device offers the possibility to interrogate all input and output states by SMS. A code
word is therefore sent by SMS to the device. The code word can be changed. The
standard code word is: ?#all
The answer is send to the same phone number (phone number identification). The states of
the inputs and outputs are displayed as follows in the SMS message:
•
Message at the start
A message will be sent with this report according to a preset number for each start up
(switching on / return of power) of the SMS relay. (According to the phone number entries
in the list.) The message contents can be edited.
•
Messages in case of power failure
In case of voltage failure the SMS relay sends a last signal to receiver No.1 to 5 of the
status messages. The message contents can be edited.
•
Periodical message
The periodic message provides information. A message is sent periodically. The
message can be sent daily (time), weekly (time, weekday) or monthly (time, date). The
message contents can be edited. It is for checking functionality or operation confirmation.
PLEASE NOTE
6.6
Input configuration
6.6.1 General
The SMS Relay has 6 inputs. Each one of these inputs can send an SMS message, which
can be chosen at will, to a predefined telephone number either in case of activation or loss of
the input signal (up to 5 various numbers).
PLEASE NOTE
Basically two events can trigger an SMS: the change from LOW-to-HIGH and the inverse the
change from HIGH-to-LOW. One or both events can be activated. A separate text message
can be entered for each event.
If the SMS Relay does not receive an acknowledgement within a certain preset time from the
receiver, the event message will be sent to the next receiver. This means that the device
Operating instructions SMS Relay
I:00010 Eingänge 1 bis 6
O:0101 Ausgänge 1 bis 4
The display of special characters in the GSM network can cause
problems. Please use only text characters and figures. The
programming software identifies special characters and an errror
messages will occur.
Please mind every input needs at least one phone number in his list. It
doesn't matter if the input is connected or not or the status messages
are set inactive. If the receiver field is empty, the software can't save
the file or the file can't be downloaded to the SMS Relay.
12
0 = AUS / 1 = EIN
0 = AUS / 1 = EIN
ba_smsrelay_0706e.doc