Amphenol Procom XG-COMBI MOUNT Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Cremagliere e cavalletti Amphenol Procom XG-COMBI MOUNT. Amphenol Procom XG-COMBI MOUNT 3.

Stampa la pagina
XG-Combi Mount
INSTALLATION
XG-Combi mount antenna types can be mounted anywhere on the car, however, roof
top mounting is always recommended.
The oblong XG-Combi mount is able to be mounted on the often very narrow strip on the
rear wing between the trunk lid and the side of the car.
Mounting can take place with access from the outside or inside when drilling an 19 mm
dia. hole.
A good contact surface on the inside of the car body must always be ensured, thus
enabling the base plate to get in direct contact with the metal parts of the car, which is of
utmost importance for proper performance of the antenna.
When cleaning the car in car-washing machines, the whip is easily removed using a fork
spanner, size 9 mm. The whip is refitted again by screwing it onto the thread stud and
tightening it lightly with the spanner.
As the XG-Combi mount is internally equipped with a bendable section, the antennas
can always be adjusted to an upright position independent of the tilt angle of the
installation spot (up to 30° tilt).
1. INSTALLATION DIMENSION
PROCOM A/S reserves the right to
amend specifications without prior notice
ASSEMBLY INSTRUCTIONS
Put GPS-FME-connector-cable through the gasket (2).
Put the gasket (2) + GPS-part (1) over the body (B).
Put the body (B) + gasket (3) + GPS-part (1) through the ø19 mm hole.
Put the housing (4) over the body (B) and be sure that the GPS-part (1) fits into the square
hole in the body (B).
Put the threaded part over the body (B) and tighten max. 4 ±1 Nm!
Put the corrugated plastic unit (6) over the body (B).
Mount the antenna whip se figure 4.
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
PROCOM A/S • Smedetoften 12
DK 3600 Frederikssund • Denmark
Page: 3 of 3
Last edited: 2021/12/10