Dover Triton 9640 Procedura di conversione - Pagina 9

Sfoglia online o scarica il pdf Procedura di conversione per Apparecchiature industriali Dover Triton 9640. Dover Triton 9640 10.

Slowly extend the slide tray on the rails. Stop when

the rails are fully extended. This is the service position

for the slide tray.

Slide Tray installed. Shown in service

position

5. Place Dispenser Mechanism on slide tray, allowing

enough space at the rear of the mechanism to allow

access to the control board. Do not slide the

mechanism under the rear tabs on the tray until

directed to do so in a later step!

Location of slide tray tabs.

Place dispenser mechanism on slide

tray.

RITON

YSTEMS

9640-

-9600

ONVERSION

ROCEDURE

6. Plug the Dispenser Power Cable (09600-00013) into

the mating connector (PL2) also located on the back

of the dispenser. Make sure the DC power cable

is plugged into the mating connector properly

before proceeding.

7. Plug the Dispenser Data Cable (09600-00027) into

the mating DB25 connector (PL6) located on the back

of the dispenser, using a small flat head screwdriver.

Dispenser mechanism on slide tray.

Do not slide mechanism under rear

tabs until power and data cables have

been connected!

Attach power cable to dispenser control

board.

Attach data cable to dispenser control

board.