amPHILI FUJI S0176PH Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Cappa di ventilazione amPHILI FUJI S0176PH. amPHILI FUJI S0176PH 4.

mPHILI Inc.

Installation Steps

：(For reference only, actual procedure may vary)

Preparation Understand the work：

1. New installation or replacement

2. Minimum width: 30 inch；

3. Exit: upward or backward

4. Shape of the duct: Square（3- ¼ x 10 inch）or round（6 inch Dia. Or other size）；

5. Decide if duct adapter needed（Reno Depot，HomeDepot，etc）；

Step 1

Open the package, check all the accessories. Choose the correct

duct exit(Square or Round) comes with the Range hood.(Default,

round exit installed)

（WARNING: The glass air guide is fragile1 Do not break it.）

(Tips: Put the foam in the package under the range hood to

protect the glass.)

It is recommended to remove the metal "L" shaped brackets from

Step 2

(Optional)

both sides.

Step 3

For stainless steel, do not remove the protection film now! You can life the foam edge to make

it easier to remove the foam later after installation completed.

In order to keep a gap between the back of the, range hood body and wall, use the tape to fix 2

Step 4

(Optional)

layers of the card board onto the wall. This gap will help to install the three screws back later

on the fact plate.

（This step is optional, just make sure the rang hood is not too close against the wall, leave a

gap between the range hood back and wall）

1-888-680-0086

www.amphili.com

Figure 1

Square to round adapter，

Standard size: 3- ¼ x 10 inch.

Figure 2

Round duct，

Standard: 6 inch Dia.

If the original duct is only 4 inch, need a 6 inch to 4

inch adapter or to cut the 6 inch duct to fit into 4 inch

then fixed with a screw and sealed with the

aluminum tape.

ver.2012-03-29