Dover TWG TULSA WINCH 707W Manuale di servizio - Pagina 9
Sfoglia online o scarica il pdf Manuale di servizio per Winches Dover TWG TULSA WINCH 707W. Dover TWG TULSA WINCH 707W 18.
Stampa la pagina
1. Thoroughly clean all parts. Replace those that show wear or damage.
(Item 5)
2. Inspect the drum
replace if necessary.
3. Attach the output shaft
making sure the vent
Torque Specifications Chart on page 15 of this manual)
4. Install the retaining ring
(Item 43)
5. Attach the rods
(Items 2 & 60)
. Torque to specification
manual)
.
6. If necessary, install a new bearing
7. Lay the unit down so that the rods
(Item 5)
onto the output shaft
8. Install the planet gearset
onto the shaft
(Item 32)
(Item 8)
9. Insert the sun gear
installed down, facing the output shaft.
10. Install a new o-ring
into the bearing carrier
into the drum.
11. Position the side plate
side plate with twelve capscrews
Specifications Chart on page 15 of this manual).
12. Install the brake subassembly into the side plate
(Item 21)
brake housing
(Item 26)
carrier
and that the holes for the motor are in the correct orientation. Also, make
sure that the level and vent plugs in the cover are properly oriented. Install eight capscrews
(Item 9)
and torque them to specification (
manual
).
(Item 7-1)
13. Install a new o-ring
valve assembly. Install two capscrews
(see Torque Specifications Chart on page 15 of this manual)
specification
(Item 46)
14. Reconnect the hose
15. Fill both the gearbox and the brake section with the proper amount and type of lubricants as
Recommended Oil
instructed in the
ASSEMBLY
for structural integrity and the gear teeth for excessive wear, then
(Item 32)
to the side plate
(Item 30)
is oriented properly, then torque them to specification
(Item 3)
onto the output shaft
(Item 12)
and base
(see Torque Specifications Chart on page 15 of this
(Item 28)
(Item 43)
(Item 32)
being careful not to damage the seal
(Item 4)
into the drum
.
into the planet gearset
(Item 7-6)
and, if necessary, a new bearing
(Item 26)
. Grease the o-ring and seal and install the bearing carrier
(Item 1)
on top of the rods
(Items 2 & 60)
aligns with the bearing
see Torque Specifications Chart on page 15 of this
on the face of the motor and re-install the motor/counterbalance
(Item 51)
to the brake housing
section on page 6 of this manual.
(Item 50)
with six capscrews
.
(Item 32)
.
(Item 50)
to the side plate
(Item 7-3)
and oil seal
into the drum.
(Item 12)
and base
are pointing up. Set the drum
(Item 5)
, making sure it's installed correctly
(Item 4)
. The slot in the sun gear must be
(Item 28)
(Item 43)
and base
. Torque to specification
(Item 1)
, making sure that the pilot of the
(Item 28)
and seal
(Item 52)
and washers
(Item 21).
9
(Item 62)
(see
with twelve capscrews
(Item 7-3)
.
(Item 7-3)
and seal
(Item 12).
Attach the
(see Torque
(Item 7-3)
in the bearing
and torque them to
.
,