Dowco X24RS Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Attrezzatura per la nautica Dowco X24RS. Dowco X24RS 5. 2018-2019 g3 full / front enclosure / double canopy

Stampa la pagina

NOTE:

This enclosure is designed to fit the 2013 G3 X 24RS Pontoon Boat that has the aft canopy brackets in the following locations:

Main Bracket from back 122"

Measurements should be taken from the main bracket of the aft canopy bracket as shown below for bow and extended aft brackets/hinges.

If brackets are off more than 1 inch in either direction, the enclosure WILL NOT FIT.

All measurements are taken to the center of the brackets.

EXT. AFT

FIG. 1

BUTTON MOUNTING DETAIL

DECK BUTTON

1/4-20 x 1 1/2

CSINK FASTENER

1/4-20 x 3/4

BARREL NUT

NOTE:

Your pontoon has been pre-assembled with an aft canopy and aft canopy frame from G3. The aft canopy that is supplied with the pontoon is

not designed to be used with an enclosure. You must remove the standard aft canopy and replace it with the aft canopy that is supplied with the

purchase of your enclosure. Once the new canopy is installed, raise the entire unit to the "up" position. Make sure the aft canopy is centered on the

frame between the port and starboard sides. This step is very critical, it will determine the final appearance of your completed enclosure.

BRACKET LOCATIONS & ASSEMBLY (FIGURES 1 & 2)

STEP 1

Bracket location (A). Measure and place a mark on the top rail 102" forward from aft main bracket. Button location (B). Measure and place a

mark on the top rail 26" forward from (A).

STEP 2

Center the brackets/buttons at each mark as shown in Figure 2. Transfer the centers of each hole at the bottom of the bracket on to the rail

using a center punch.

STEP 3

Using 5/ 1 6" drill bit, drill holes completely through the top rail.

STEP 4

Replace the brackets. Insert a 1 3/4" bolt from the top through the bracket and the rail. Place a barrel nut on each bolt and tighten (Figure 2).

STEP 5

Follow the same procedure for the other side.

Dowco Marine, Inc. | 1610 Frisco Drive, Lebanon MO 65536 | dowcomarine.com | (800) 404-5252

Rear HDA 29.5"

29.5"

31"

48"

(NOT REPRESENTATIVE OF ACTUAL BOAT)

FWD HDA 20"

AFT

MAIN

20"

122"

TO BACK OF DECK

BOW

102"

19 "

140133-00 | 02/19