Follett Maestro Chewblet 400 Series Manuale di installazione e assistenza - Pagina 14
Sfoglia online o scarica il pdf Manuale di installazione e assistenza per Fabbricatore di ghiaccio Follett Maestro Chewblet 400 Series. Follett Maestro Chewblet 400 Series 20. Ice machine and top kit
Anche per Follett Maestro Chewblet 400 Series: Manuale di installazione e assistenza (20 pagine), Manuale di installazione, funzionamento e assistenza (20 pagine)
Stampa la pagina
Operation
Weekly exterior evaporator unit care
The exterior may be cleaned with a stainless cleaner such as 3M Stainless Steel Cleaner & Polish or equivalent.
Recommended semi-annual ice machine/evaporator unit cleaning (every 6 months)
Solution A – Sanitizing solution:
Combine 1 oz (250ml) bleach with 2 gal (8L) hot water or
equivalent 5.25% sodium hypochlorite solution.
Solution B – Ice machine cleaner: Prepare one gallon (3.8L)
of Follett SafeCLEAN
™
ice machine cleaner (one 7 oz packet) or
equivalent. Solution temperature must be at least 120 F (49 C)
Warning: Most ice machine cleaners contain citric or phosphoric
acid that can cause skin irritation. Read caution label on product
and follow instructions carefully.
1.
Remove ice machine panels required to gain access to water
reservoir components (Fig. 15) and electrical control box.
2. Locate ice machine electrical box and turn compressor switch
off.
3. Dispense all ice from dispenser.
4. Shut off water to ice machine.
5. Drain water from reservoir through fl oat/evaporator drain line
(Fig. 15.3). Reinsert hose into hose clip (Fig. 15.1).
6. Fill reservoir (Fig. 15.2) with Solution B.
7.
Restart ice machine and allow gearmotor to run with the
compressor off for 15 minutes.
8. While waiting 15 minutes, follow steps 8a through 8c.
a) Remove ice compression nozzles (Fig. 16.1). Soak in
Solution B.
b) Descale drain pans (Fig. 16.2) by grasping fi rmly and
gently bending up and down. Vacuum residue out.
c) Inspect all drain lines. Clean as necessary with Solution B.
9. Turn ice machine power off.
10. Drain Solution B through fl oat/evaporator drain line
(Fig. 15.3). Rinse evaporator by fi lling reservoir (Fig. 15.2) with
potable water and draining evaporator through fl oat/evaporator
drain line (Fig. 15.3) three times. Reinsert hose into hose clip
and plug into end of drain line (Fig. 15.1).
11. Connect ice transport tubes (Fig. 16.3) directly to evaporator
outlet ports (without ice compression nozzle) (Fig. 16.4).
12. Fill reservoir (Fig. 15.2) with Solution A.
13. Turn ice machine power on (to allow gearmotor to run).
14. Wait 10 minutes. Turn compressor switch on.
15. Keep reservoir (Fig. 15.2) full of Solution A while making ice for
20 minutes.
16. Turn compressor switch off
Fig. 15
1
3
Fig. 16
14
2
1
3
4
2