Amplitec W20-GSM Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Ripetitore Amplitec W20-GSM. Amplitec W20-GSM 15. Indoor single band selective repeater

Installation Steps:

A) Use percussion drill to make four Φ6 holes on the wall according to

above hole diagram.

B) Fill the holes with expanding plug

C) Put the tapping screw through the holes and fit tightly with the

expanding plug, and fasten the repeater onto the wall.

D) Make sure that the installation is firm and correct

4.3 Connection

Connection of RF cable

Input Port : donor antenna cable is connected with BS Port;

Output Port : service antenna cable is connected with Output Port;

Grounding

Please connect one end of a copper wire with the intersection size of

16mm2 with the grounding screw, and the other end with the grounding system

of the building. It is requested that the grounding impedance shall be less than

10Ohm.

Power supply connection

Installation of air switch is recommended for the convenience of power

supply switch off.

Please use three-pin plug to assure good grounding

Please use the grounding screw, nut, washer to connect the grounding wire and

repeater shell

Lightening Arrestor can be installed if necessary

Confidential

User Manual of W20-GSM Indoor single band selective repeaters

Page 9