AmpliVox S1204 Manuale di istruzioni
Sfoglia online o scarica il pdf Manuale di istruzioni per Altoparlanti AmpliVox S1204. AmpliVox S1204 2. Wireless powered speakers
Anche per AmpliVox S1204: Specifiche tecniche (1 pagine)
Stampa la pagina
AUDIO COMPANION WIRELESS POWERED SPEAKER
PORTABLE MULTI-MEDIA STEREO SPEAKER/AMPLIFIER
SET UP:
INSTALL POWER SUPPLY
The Battery pack is standard. Optional Power Supplies may be substituted. Model S1460, International
AC Adapter (110/220V, 50/60Hz). Model S1452, 12 Volt DC adapter (automotive cigarette lighter plug-
in). Model S1465, NiCad battery Pack.
TO INSTALL OR REPLACE BATTERIES
Loosen four thumbscrews and remove battery door from back of speaker. Remove battery holder from
amplifier. Insert 10 new Alkaline "D" cell batteries, observing polarity, or replace with S1465 NiCad
battery pack. Carefully replace battery holder. Reposition battery door and fasten four thumbscrews.
Do not mix battery types or attempt to recharge alkaline batteries - equipment damage, safety hazard or
fire could result. Remove batteries if the amplifier is not going to be used for extended periods of time
to prevent leakage.
TO OPERATE:
Turn amplifier on (large rocker switch located on the front of the amplifier). The red light will go on,
showing that power is available. The S1204 will operate only with a Kima wireless speaker transmitter
model S1670. Make sure that the S1670 Kima wireless speaker transmitter is turned on and a signal
source is plugged into its Audio input jack. Adjust the Kima transmitter volume control for maximum. A
temporary burst of noise is heard while the receiver built into the S1204 speaker acquires the desired
signal from the S1670. Rotate WIRELESS control or if using cabled Line input the VOLUME and
TONE control knobs to obtain desired loudness level throughout the coverage area.
NOTE: The frequencies used by the S1204 and the Kima wireless speaker transmitter model
S1670 are not on clear channels and may be used by other devices. If the unit receives
interference, turn the Wireless control completely down, and a cable must be used from the
signal source to the S1204 Line input.
ON-OFF
When power switch is in the ON position, the red light will be on.
DC IN
Connection for optional power adapter:
•
S1460 International AC Adapter/Recharger (110/220V, 50/60Hz)
•
S1452 12 Volt DC (automotive cigarette lighter) Adapter
AUXILIARY
To add pre-recorded music or sound effects during your presentation, just plug your CD player, tape
player or computer sound card into the LINE IN jack. Separate VOLUME and TONE control knobs let
you balance the program source with the live microphones.
MODEL S1204