AmpliVox SN3045 Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Sistema di leggio AmpliVox SN3045. AmpliVox SN3045 8. Patriot series lecterns

Stampa la pagina

WIRELESS BODYPACK TRANSMITTER—OPTIONAL— MODEL S1690T

•

The transmitter bodypack is operated by 1 - "AA" 1.5 Volt alkaline battery.

Slide off battery cover (A) and install battery as shown. Make certain the bat-

tery is fully seated in its compartment so the cover slides in place easily. Bat-

tery life with alkaline batteries is approximately 8 hours of operating time.

•

Select a channel (1-16) on side panel (B) using the supplied screw driver to

select channel number. Channel selected should match channel on receiver.

When transmitter and receiver are set to correct channel the RF indicator on

receiver will glow red when bodypack transmitter is turned on. To check bat-

tery, turn on before turning on receiver. If LED (C) changes green to red, or

does not light up, replace battery.

•

Plug the Lapel / Headset microphone into the Mic Input Jack (D). The micro-

phone can be clipped to a necktie or other clothing, using the supplied clip.

The lapel mic should be placed under the chin, as close to the center of the

body as possible.

•

Slide the power ON / OFF / MUTE / STANBYswitch (E) to the ON position

(the LED indicator light will illuminate green). Replace batteries when this

LED turns red.

•

GAIN SWITCH (F): If you are a soft spoken person then set the switch to the

10 dB position. If you are a loud speaking person then set the switch to the

-10 dB position. Adjust to prevent distortion while speaking.

WIRELESS HANDHELD MICROPHONE—OPTIONAL— MODEL S1695

BATTERIES

1. Hold the body of microphone in hand and twist off bottom section of

microphone.

2. Insert two "AA" batteries.

3. Twist bottom section back on to microphone.

BATTERY STATUS

The life expectancy of the two batteries is about 10 hours. When the "BATTERY"

symbol on the display screen keeps flashing the batteries should be replaced

immediately.

Functions

1) Interchangeable

Microphone Head

2) LCD Screen

3) Power / Mute Control Switch

4) Select Button

5) Microphone Input Sensitivity

Adjustment—is used to set

the gain of microphone. If you

are a soft talking speaker you

will need to turn the control

counter clockwise. Turn clock-

wise if you are a loud talker.

Use plastic screwdriver that is

supplied.

BATTERY COVER REMOVED

• TURN ON MICROPHONE: Press and hold the

"POWER/MUTE" (3) button until LCD screen

lights up.

• TO MUTE: Press "POWER/MUTE" button twice

to MUTE. Channel number will flash when mut-

ed. Press button again twice to

remove "MUTE".

• TURN OFF MICROPHONE: Press and hold the

"POWER/MUTE" (3) button for 2 seconds to

turn microphone "OFF".

• SELECT CHANNEL (Manual): Press and hold

the "SELECT" (4) button for 2 seconds until you

only see the word Channel and channel number.

To change channel, when flashing, press the

"SELECT" (4) button until you reach the desired

channel. Flashing will stop after 10 seconds and

channel is now set.

• LOCK / UNLOCK CHANNEL: Press the

"POWER/MUTE" (3) button and "SELECT"

button at the same time to lock or unlock chan-

nel. When locked, channel cannot be changed.

"LOCKED" symbol appears in upper left-hand

corner.