CARBEL C-60 Plus Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Camino da interno CARBEL C-60 Plus. CARBEL C-60 Plus 14.

The building work must be finished in such a way that the woodburner can expand during operation: the brickwork

must never be supported on or against the sides of the appliance. Leave a minimum expansion joint of 0.5 cm on

each side and at least 1 cm the top of the front.

LAYOUT VIEW

VISTA EN PLANTA

OPERATION

Fans

Fans at the bottom of the fireplace are operated by the switch or automatically by means of a safety

thermostat only if the temperature reaches 50 °C at the bottom of the fireplace.

You can vary the fan speed at any time. At a slower speed, operation will be quieter and the room will be

heated more gradually. When operating with a strong fire, it is advisable to adjust the fans to a faster speed to cool

the woodburner more and heat the room faster.

NOTE. To avoid overheating, the woodburner must be connected to the mains if there is a fire burning in it.

COMBUSTION

To achieve a good, clean, green (CO-free) combustion, when the wood is well lit and a high temperature has

been reached, close the primary air inlet (via the ash box) almost completely. In this way, the combustion air

(preheated in the upper section of the fireplace) enters through the top of the fireplace near the glass, resulting in

better gas combustion. You will notice this in an increase in flames and temperature.

Woodburners and inserts are intermittent combustion appliances. This means that they should be lit, loaded with

an approximate weight of fuel as recommended by the manufacturer for each model, followed by a full combustion

cycle and fuel reloads after each combustion cycle.

Good combustion is necessary for optimum performance and a better view of the flames through the glass.

Guidelines:

- Maintain a high and constant temperature in the fireplace. Accordingly, the fireplace door must be closed at all

times and opened only to load firewood, which must be done as quickly as possible

- Do not take a long time when loading firewood and wait for the end of the combustion cycle, when the flames of

the previous load disappear.

A full combustion cycle comprises the following:

1. A short period after reloading when the wood begins to heat up without flames. The time until the flame lights is

an indication of the fireplace temperature. If you wait too long to reload firewood, the temperature falls too low and

the new load of firewood does not light well. This has a negative effect on combustion and dirties the glass.

2. The temperature of the firewood increases rapidly and it begins to break up, emitting gas that ignites if the

fireplace temperature is appropriate. The fireplace temperature begins to increase as the fuel emits more gas and

the flames increase.

MINIMUM

EXPANSION

JUNTA DE DILATACION

JOINT 0.5 cm

MINIMO 0'5 cm.

MINIMUM

JUNTA DE DILATACION

EXPANSION

MINIMO 1 cm.

JOINT 1 cm

SECTION VIEW

VISTA PERFIL