AmpliVox SW232 Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti AmpliVox SW232. AmpliVox SW232 6. Wireless voice carrier pa system
Stampa la pagina
SPEAKER SET-UP
S1204 Speaker
S1690T Microphone
Transmitter
Channel Selector
S1690T / S1691T
To Operate Model S232 with Dynamic Microphone
Plug 1/4" plug end of handheld microphone cable into the "DYNAMIC" jack on front panel of amplifier.
Turn amplifier on. Turn microphone on and talk into microphone. Rotate "VOLUME" control knob to obtain desired loudness level.
I
W
M
NTERNAL
IRLESS
ICROPHONE
Select channel (1-16) on panel (A). Channel number must match channel number on wireless microphone transmitter (S1690T). Use
supplied screwdriver to select channel number.
W
M
IRELESS
ICROPHONE
Belt clip on the back of the unit clips the transmitter onto a belt or the transmitter simply can be put into a pocket. Plug the lapel / head-
set microphone into the Mic Input Jack (C). The lapel microphone can be clipped to a necktie or other clothing, using the supplied clip.
The lapel mic should be placed under the chin, as close to the center of the body as possible.
Rotate the Channel Selector Switch (B) on the wireless microphone transmitter to the same channel selected on receiver (
Slide the power ON/OFF switch
number as the wireless receiver, the LED light on the side panel (A) of the amplifier will light when amplifier is turned "ON".
Wireless Speaker Connection (S1691T)
Connect provided cable from the MIC INPUT JACK (C) on the S1691T TRANSMITTER into the LINE OUT JACK (E) on the amplifier.
On the S1204 Speakers select a wireless channel number that is not the same as on the S1690T microphone transmitter. If you chose
Channel 1 on the S1690T microphone transmitter, choose Channel 10 for the S1691T speaker transmitter and S1204 speakers. Keep
the Channel numbers far apart to avoid interference between the two.
To Operate
Turn amplifier "ON". The wireless receiver has a separate "ON-OFF" switch and is located just below main power switch of amplifier.
Slide to "ON" position. Make sure both transmitter (S1690T) and amplifier/receiver are on the same frequency channel. On the S1690T
wireless transmitter, move the power switch to "ON". RF LED on side of amplifier will light, meaning that it is receiving signal. If RF
LED does not light, check channel numbers. Speak into Lapel /Headset microphone and rotate "VOLUME" control knob to obtain de-
sired loudness level.
Wireless channel number must match on both speakers with the S1691T Wireless Transmitter
B
A
Top Panel
S1690T / S1691T
B
D
C
R
(
ECEIVER
ON SIDE OF AMPLIFIER
T
(S1690T)
RANSMITTER
(D)
to the ON position (the LED indicator light will illuminate green). If you are on the same channel
E
S1691T Speaker
Transmitter
)
S1204 Speaker
CAUTION!
Speakers can not be
no more then 300 ft.
apart from S1691T
Transmitter
A
).
5