AMPTRON P750 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Alimentazione AMPTRON P750. AMPTRON P750 9. Portable

Charging methods

How to use a solar panel to charge?
1. Using a compatible solar panel purchased from AMPTRON® (optional accessory),
unfold the solar panel and face it towards the sun. Then connect the Anderson
plug adapter cable to the input port on the P750, and the solar panel to the
Anderson plug adapter.
2. Using a solar panel purchased from a third party, a solar charge controller with an
output of about 16.8V should be connected. Alternatively, contact Amptron to
check if your solar panel is compatible to be connected directly without a charge
controller, or Amptron can provide you with a compatible solar charge controller.
The maximum supported solar power is 500W. Place the solar panel and face it
towards the sun, then connect the solar charge controller to your solar panel as
well as the one side of the Anderson plug adapter, and connect the other end of
the adapter to the input port on the P750. * Please pay attention to the +/- poles.
Note: It is recommended to remove the solar panel or turn off the solar input once
the battery is fully charged.
1.

How to use the mains supply to charge?

Follow the steps as shown below:
1. Plug the one end of the adapter into the charging port on the P750.
2. Plug the other end of the adapter plug into the mains supply socket to start
charging.
3. It is recommended to remove the charging cable after the battery is fully charged.
Do not use a 3rd party adapter to charge this product.
8
2.
How to use a motor vehicle to charge?
Follow the steps as shown below:
1. Using the car cig charging adapter, plug one end of the cable into the
charging port on the P750. Plug the other end of the car cig charging cable into
the car cigarette lighter socket, then run the vehicle to start charging.
2. Using the optional 15A Anderson plug DC-DC charger, plug the one end of the
cable into the charging port on the P750. Plug the Anderson end of the cable into
an Anderson plug in the vehicle, then run the vehicle to start charging.
Note: It is recommended to install a voltage sensitive relay (VSR) to prevent the
Anderson plug DC-DC adapter from draining the starter battery.
Estimated Charging Times
Charging method
Mains supply charging (67W)
Car charging (50W)
60W solar panel
100W solar panel
500W solar panel
15A Anderson DC-DC charger (250W)
Estimated charging times
11 Hours
15 Hours
12-20 Hours
7-13 Hours
1.5-3 Hours
3 Hours
9