AIRSLED AM2201 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Martinetti AIRSLED AM2201. AIRSLED AM2201 8. Standard & heavy-duty appliance mover

Stampa la pagina
OPERATING YOUR AIRSLED
•
Once the air beams are in position and all
connections are snug, you are ready to plug your
system into a grounded electrical outlet.
•
Strap the blower comfortably over your shoulder and
engage the power switch.
•
BE PREPARED to brace and control the load once
your Airsled system is activated. Using both hands to
control and maneuver the load at all times is
recommended. See figure 5.
CONTROL AND MANEUVERABILITY
•
All Airsled systems have an air flow controller. See figure 6. By fully
opening the controller, less air will flow into the air beams. This can help
reduce the lift especially in situations where overhead clearance is
limited (e.g. less than 2").
•
When overhead clearance is less than 2", the load may get "wedged"
in place once it is lifted by the air beams. Overhead with less than 2"
clearance may also get damaged when the load is lifted. If
fully opening the air flow controller does not resolve this
issue, you can rapidly toggle the power switch between the
ON/OFF positions. This will partially inflate the air beams
allowing you to slowly move the load.
toggle approach requires two operators and should be
done using extreme caution to avoid injury or damage.
•
Systems with dial-controlled, VARIABLE SPEED performance.
(see figure 7) can have the rate and height of air beam inflation
controlled making the load less likely to get wedged due to tight,
overhead clearance. If clearance is less than 1", it is
recommended you turn up the air flow gradually.
•
Tilting may occur if the load is not optimally positioned
over the air beams (e.g. object is up against a wall and air
beams only extend slightly through the rear). If the load
tilts away from you, you can use the Airsled foot brace by
laying it across the rear of the air beams and applying
downward pressure with your foot. See figure 8. If the load
tilts toward you, the air beams may be pushed under too
far and will need to be pulled back. If the load tilts to the
side, you may need to shift one or both of that air beams
to offset the tilt.
GOING OVER POROUS SURFACES SUCH AS CARPETING
All Airsled systems come with plastic Rough Surface Adapters (RSAs). The RSAs are 10" W x 36" L and
laid on top of the porous surface. The air beams MUST BE PLACED OVER THE RSAs in order for your
system to perform properly. See figure 9. Your system comes with 4 RSAs allowing you to create a short
track to move the load. If moving the load over long distances, heavy carboard paper such as Ram
®
Board
floor protection paper can be used. See figure 10.
– this
WARNING
70 – A Aleph Dr.
Newark, DE 19702
Page 3 of 7
Figure 5
Figure 7
Support Email:
Toll Free Number: 1-800-AIRSLED (1-800-247-7533)
Figure 6
Figure 8