AIRSLED AC40DS Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Cremagliere e cavalletti AIRSLED AC40DS. AIRSLED AC40DS 5.

Step 5: The ½" thick HDPE shelf should be tight up against the washer's top with little to no gap between

the two surfaces. Some washing machine designs have a curved front that can create a gap. If a

gap is present, Airsled's Rough Surface Adapters (RSAs) can be placed over the gap to create a

continuous track. Once you are satisfied with the placement of the HDPE shelf (with or without

the RSAs), position the air beams under the dryer. They should pass completely under the dryer

and extend out the back.

Step 6: Connect all the Airsled components and turn on the blower to perform the move. Pulling the air

beams by the inlets is recommended. The safety stopper acts as a guide to ensure the dryer is

not pulled too far forward. The entire dryer must be pulled far enough forward so that is clears the

washing machine's top.

Step 7: After the dryer has been pulled forward and has cleared the washing machine, you can turn off

your Airsled, remove the air beams and safely roll the dryer to the desired location.

DO NOT ATTEMPT TO LOWER THE DRYER. THE ALLDOLLY

AND ARISLED STACKED DRYER SHELF KIT ARE INTENDED TO

ONLY SUPPORT THE LOAD AT THE FIXED HEIGHT REQUIRED

TO SAFELY REMOVE THE DRYER. ATTEMPTING TO LOWER

THE DRYER BY LOOSENING THE ALLDOLLY KNOBS MY LEAD

TO INJURY AND/OR PROPERTY DAMAGE.

WARNING

70 – A Aleph Dr.

Newark, DE 19702

Page 3 of 4

Support Email:

Toll Free Number: 1-800-AIRSLED (1-800-247-7533)