Electrolux CARAVAN RM 4601 Manuale - Pagina 7

Sfoglia online o scarica il pdf Manuale per Frigorifero Electrolux CARAVAN RM 4601. Electrolux CARAVAN RM 4601 11.

FIG. 2

Securing the refrigerator

After the refrigerator is put in place, (insuring a combus-

tion seal at the front frame), the refrigerator is to be

secured in the enclosure with six screws. The screws

have to be installed in the following order:

A. Two screws installed through the front base.

Secure the refrigerator to the floor with two screws:

One screw through the hinge and into the floor, and

on the opposite side one screw through the front

base. (See Fig. 3).

A cover plate (shipped as a loose part) is to be

attached after the refrigerator is secured in the

enclosure. (See Fig. 3).

FIG. 3

B. Two screws installed in the top frame.

The top decoration panel must be removed from the

refrigerator before the screws can be installed. Open the

upper door and gently push the tabs out of the hole in

the hinge (both sides) with a flat blade screwdriver.

Carefully tilt the top decoration panel and lift up to

remove from top frame. See fig. 4.

Install the two screws in the top frame, the holes are

accessible from underneath.

FIG. 4

Seal the opening for the screws with aluminium tape.

Replace the top decoration panel. Make sure the tabs

snap back into the holes in the hinge plate.

C. Two screws installed in the rear base.

See fig. 5.

Failure to follow the sequence in securing the refrigerator

in the enclosure can cause leakage between the frame

and cabinet. Any space between the counter, storage

area or ceiling and top of the refrigerator greater than

40 mm should be blocked. The heat produced at the rear

of the refrigerator will become trapped in this space,

making the top of the refrigerator hot and reduce the

efficiency of the refrigerator.

FIG. 5