en Installation instructions
13.4 Instructions for the electrical
connection
In order to be able to safely connect the appliance to
the electrical system, follow these instructions.
WARNING ‒ Risk of electric shock!
It must always be possible to disconnect the appliance
from the electricity supply. The appliance must only be
connected to a protective contact socket that has been
correctly installed.
▶
The mains plug for the mains power cable must be
easily accessible after the appliance is installed.
▶
If this is not possible, an all-pole isolating switch
must be integrated into the permanent electrical in-
stallation according to the conditions of overvoltage
category III and according to the installation regula-
tions.
▶
The permanent electrical installation must only be
wired by a professional electrician. We recommend
installing a residual-current circuit breaker (RCCB)
in the appliance's power supply circuit.
Sharp-edged components inside the appliance may
damage the connecting cable.
▶
Do not kink or trap the connecting cable.
¡ The connection data can be found on the rating
plate inside the appliance.
¡ To see the rating plate, remove the grease filter.
¡ The connecting cable is approx. 1.30 m long.
¡ This appliance complies with the EC interference
suppression regulations.
¡ The appliance corresponds to protection class 1.
Therefore, only use the appliance with a protective
earth connection.
¡ Do not connect the appliance to the power supply
during installation.
¡ Ensure that the protection against contact is guaran-
teed during installation.
13.5 Secure installation
Follow these safety instructions when installing the ap-
pliance.
WARNING ‒ Risk of poisoning!
Risk of poisoning from flue gases being drawn back in.
Room-air-dependent heat-producing appliances (e.g.
gas, oil, wood or coal-operated heaters, continuous
flow heaters or water heaters) obtain combustion air
from the room in which they are installed and dis-
charge the exhaust gases into the open through an ex-
haust gas system (e.g. a chimney). With the extractor
hood switched on, air is extracted from the kitchen and
the adjacent rooms. Without an adequate supply of air,
the air pressure falls below atmospheric pressure.
Toxic gases from the flue or the extraction shaft are
sucked back into the living space.
10
▶
Always ensure adequate fresh air in the room if the
appliance is being operated in exhaust air mode at
the same time as a room air-dependent heat-produ-
cing appliance is being operated.
▶
It is only possible to safely operate the appliance if
the pressure in the room in which the heating appli-
ance is installed does not drop more than
4 Pa (0.04 mbar) below atmospheric pressure. This
can be achieved whenever the air needed for com-
bustion is able to enter through openings that can-
not be sealed, for example in doors, windows, in
conjunction with incoming/exhaust air wall boxes or
by other technical means. An incoming/exhaust air
wall box alone does not ensure compliance with the
limit.
▶
In any case, consult your responsible chimney
sweep. They are able to assess the house's entire
ventilation setup and will suggest the suitable ventil-
ation measures to you.
▶
Unrestricted operation is possible if the appliance is
operated exclusively in air recirculation mode.
WARNING ‒ Risk of suffocation!
Children may put packaging material over their heads
or wrap themselves up in it and suffocate.
▶
Keep packaging material away from children.
▶
Do not let children play with packaging material.
WARNING ‒ Risk of fire!
Grease deposits in the grease filter may catch fire.
▶
The specified safety clearances must be complied
with in order to prevent a build-up of heat.
▶
Observe the specifications for your cooking appli-
ance. If gas and electric hobs are being operated
together, the largest specified clearance applies.
▶
The appliance must be installed with no more than
one side directly next to a high-sided unit or a wall.
The distance between the appliance and wall or
high-sided unit must be at least 50 mm.
Grease deposits in the grease filter may catch fire.
▶
Never work with naked flames close to the appli-
ance (e.g. flambéing).
▶
Do not install the appliance near a heat-producing
appliance for solid fuel (e.g. wood or coal) unless a
closed, non-removable cover is available. There
must be no flying sparks.
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
▶
Wear protective gloves.
The appliance may fall down if it has not been properly
fastened in place.
▶
All fastening components must be fixed firmly and
securely in place.
Risk of injury from glass splinters.
▶
Protect the filter cover against impact.
▶
Do not drop the filter cover.
▶
Wear protective goggles during installation.
The appliance is heavy.
▶
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
The appliance is heavy.
▶
The appliance must not be fitted directly onto plas-
terboard or similar lightweight materials.
Stampa la pagina