Bosch SB Series Manuale di istruzioni - Pagina 22

Stampa la pagina

Operating the appliance

Switching on the appliance

1. Turn on the tap fully.

2. Open the door.

3. Switch on ON/OFF switch (.

The Eco 50° programme display

flashes. This programme remains

selected unless another programme

is selected with the button <

H or button > P.

4. Press the START button h.

5. Close the door.

The programme starts running.

Note

- for environmentally friendly operation

of the dishwasher:

For ecological reasons the Eco 50°

programme is preset whenever the

appliance starts. This conserves

environmental resources and not least

saves you money.

The Eco 50° programme is a

particularly environmentally friendly

programme. According to EU

regulation 1016/2010 it is the

"Standard programme" which is the

most efficient standard cleaning cycle

for cleaning normally soiled utensils in

terms of the combined energy and

water consumption for cleaning these

types of utensils.

O ptical display while

O p t i c a l d i s p l a y w h i l e t h e p r o g r a m m e i s r u n n i n g

the programme is running *

* depending on model

While the programme is running, a light

spot shines on the floor under

the appliance door. Do not open

the dishwasher door until the light point

is no longer visible on the floor.

If the appliance is installed at eye-level,

with flush furniture front, the light point

is not visible.

T imer programming *

T i m e r p r o g r a m m i n g

* depending on model

You can delay the start of the

programme by 3, 6 or 9 hours.

1. Switch on ON/OFF switch (.

2. Keep pressing the Preselected

starting time button 0 until the

appropriate display 3h, 6h or 9h is lit.

3. Press START button h, timer

programming is activated.

4. To delete the preselected starting

time, keep pressing the Preselected

starting time button 0 until none of

the displays 3h, 6h or 9h is lit.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when

neither of the two displays ` or X

is lit.

The end of the programme is also

indicated by an acoustic signal.

The buzzer volume can be set in 4

stages. Accordingly 0, 1, 2 or 3 displays

are lit (see water hardness table).

Factory setting: 2. This function can be

changed as follows:

1. Open the door.

2. Switch on ON/OFF switch (.

3. Hold down button > P and press

START button h until the dry

display ` and salt refill

indicator )* flash.

4. Release buttons.

5. Keep pressing button > P until

the salt refill indicator )* and rinse

aid refill indicator )" flash.

6. Release buttons.

The refill indicators )* and )"

flash and the displays # and +

are lit (= Setting 2). The set buzzer

volume can be heard.