Dragonfly Ultra Acoustiweave Manuale di installazione - Pagina 4
Sfoglia online o scarica il pdf Manuale di installazione per Schermo di proiezione Dragonfly Ultra Acoustiweave. Dragonfly Ultra Acoustiweave 8. Thin-bezel fixed projection screens
Stampa la pagina
Fixed Projection Screen Manual
Step 3. Assemble the Frame
A. Slide the short frame sections into the long frame sections.
B. Insert the 8 frame corner screws into all 4 corners of the
frame and loosely tighten to hold the frame together.
C. Hand-tighten all four screws, ensure the corners are
square, then tighten the screws completely.
D. Lift up and set aside to prepare screen material for assembly.
Step 4. Prepare the Screen Material
A. Lay the protective sheet out on the work surface, and
clean the surface and work area to avoid staining the
screen material.
B. Put on the supplied gloves before handling the screen
material.
C. Roll the screen material out onto the protective sheet,
then lay the frame down onto the material, ensuring the
corners of the frame and fabric are properly aligned as
shown in Step 4.
D. Insert frame rods into the edges of the screen as shown
in step 4.
Step 5. Attach the Screen Material to the Frame
A. Align the springs to the holes in the screen fabric.
B. Using the spring tool, attach the springs to the screen
material, following the numbering in the image to the
right, ensuring screen and frame stay aligned with
corners. Once the corners are connected, work around
the screen attaching the remaining springs.
C. Ensure
all
springs
perpendicular to the screen. Any springs installed at
an angle may cause ripples in the screen material.
Step 6. Install Brackets and Frame Bezels
A. With the film screen still laying face down, lay the thin
bezel caps on to the respective horizontal and vertical
edges of the screen. The aluminum side should be facing
up with fabric edges facing out. Refer to Image 6A.
i.
The tracks on the back of the thin bezel caps align for
a tight fit in each of the corners. Refer to image 6B.
B. Once the thin bezel frames are in place and aligned,
install the thin bezel frame brackets.
i.
10 total brackets will be used to tighten all 4 thin
bezel caps in place. 2 brackets for each of the
vertical frames and 3 brackets for each of the
horizontal frames.
C. Hook curved end of the thin bezel bracket to the
outermost track of the thin bezel cap and align it with
a sliding nut. Use the M5x6mm screws to tighten.
Note: There are 4 additional sliding nuts on the horizontal
frames, 2 on each side. These sliding nuts are used to
install the wall brackets.
© 2018 Dragonfly
are
installed
straight
Step 3
x32
Step 4
Step 5
1
6
and
11
7
2
Step 6A
Step 6B-C
4
B
C
10
12
4
5
9
8
3
Fabric
Edge
181015-1400