Drain Master CE50 Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Pulitori per tubi Drain Master CE50. Drain Master CE50 15. Electric drain cleaner

Electric Drain Cleaner - CE50

Maintenance

Procedures not specifically explained in this manual must be performed by qualified

technicians only . • Before performing any inspection, maintenance, or cleaning

procedure, place the motor switch in the "OFF" position and disconnect the machine from the electrical

supply. • Do NOT allow water to get into the motor or any other electrical components. • Do NOT use

damaged or malfunctioning equipment. If abnormal noise or vibration occurs, have the problem corrected

before further use. • Do NOT perform any inspection, maintenance, or cleaning procedure on a moving

cable. • Do NOT operate the equipment without the belt guard installed.

1. Thoroughly rinse the cable, cable drum etc with clean water after every use. This will help prevent the

build-up of sediment, dirt and chemicals in the cable and help prolong cable life. Use hot water,

detergent and/or disinfectant as necessary. Clean any other parts of the machine as required with a

clean, soft cloth.

2. Carefully tip the machine forward to drain any remaining water from the cable drum.

3. Pull the cable from the drum and dry both the cable, drum and all other components.

4. Lubricate the cable with lightweight machine oil as you feed it back into the drum.

5. If the cable drum is removed or changed, grease the bearings with general purpose grease.

1. Remove the belt guard retaining screw and remove the guard from the machine.

2. Slide the belt off the rear of the cable drum. Unhook the belt from the drive pulley then remove the belt

3. Hang the new belt from the belt pulley.

4. Hook the bottom of the belt around one side of the cable drum. Hold the belt on the drum and slowly

rotate the drum so the belt "climbs" onto the drum and is securely in place. Once the belt is in place,

rotate the drum several times by hand so the belt straightens.

5. Place the belt guard into position and secure it.

1. Remove the cable by pulling it fully out of the cable drum.

2. Remove the screw securing the cable to the drum-connect cable, then separate the cables.

3. Attach the new cable to the drum-connect cable using the screw and tighten it securely.

4. Feed the cable into the drum.

E&OE