Electrolux 30" Wall Oven Manuale di istruzioni per l'installazione
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Forno Electrolux 30" Wall Oven. Electrolux 30" Wall Oven 8. Electric wall oven
Stampa la pagina
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
The first step of your installation should be to measure your current cutout dimensions and compare them
to the cutout dimensions chart below. You may find little or no cabinet work will be necessary.
Do not remove spacers on the side walls and/or on the back of the built-in oven. These spacers
center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result
in heat damage or fire.
NOTE:
1. Base must be capable of supporting 200 pounds (90.7 kg).
2. Make sure base is level and front of cabinet is square. If the cabinet
base is not level, the oven glides will tend to slide out
when opening the door.
** NOTE: Allow at least 23¼" (59.1 cm)
clearance for door depth when it is open.
NOTE: Dimension G is critical to the
proper installation of the built-in oven. If
the oven decorative moulding does not
butt against the cabinet, or if noise is
heard on convection models, verify
dimension G to assure it is according to
the required dimension.
* Suggested distance from floor is 31" (78.7 cm).
Minimum required distance is 4½" (11.4 cm).
MODEL
30" (76.2 cm) Wall Oven
MODEL
30" (76.2 cm) Wall Oven
All dimensions are in inches (cm).
Printed in United States
B
** Door Open
(see note)
PRODUCT DIMENSIONS
A
30 (76.2)
CUTOUT DIMENSIONS AND CABINET WIDTH
Min.
F Max.
½
28
(72.4)
29 (73.7)
1
1
(3.8 cm)
C
Min.
28
/
"
3
32
(71.4 cm)
H
Spacer
31"*
D
(78.7 cm)
A
NOTE: For combination of this Built-in Oven with Warm &
Serve Drawer model no E30WD75DSS see cutout dimensions
specified in the Warm & Serve Drawer Installation Instructions.
Figure 1
B
C (Rear wrapper)
29
½
(74.9)
28 (71.1)
G (Min.)
Min.
24 (61)
28
/
(71.8) 28
1
4
1
I
/
"
4" X 4" (10.2 cm x
2
10.2 cm) opening to
route armoured
cable.
G
F
3" (7.6 cm)
2" (5.1 cm)
Junction Box
Min.
D
24
/
(61.3)
1
8
.
I
H Max
30 (76.2) Min
/
(73.3)
7
8
P/N 318201517 (0410) Rev. B
Max.
Electrical