DRAKE DAD860A Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Convertitore multimediale DRAKE DAD860A. DRAKE DAD860A 15. Digital to analog decoders

Stampa la pagina

DAD860 / DAD860A

DAD860

PROGRAM

FRONT PANEL INDICATORS & CONNECTIONS

F1 - LOCK LED - This green LED lights continu-

ously when the DAD860 is locked to the selected

incoming signal. If the lock is lost, such as when no

signal or a noisy signal is present, this LED will flash

on and off continuously

F2 - LINK LED - This amber LED flashes on and off

when the particular DAD860 is selected for pro-

gramming by the DAD860 CONTROLLER or

'DAD860 REMOTE CONTROL SOFTWARE'.

F3 - RS232 PROGRAM - This RS232 connector is

intended to attach to a PC running 'DAD860 RE-

MOTE CONTROL SOFTWARE' for programming

the DAD860 as an alternative to using the DAD860

CONTROLLER module.

F4 - ASI OUTPUT, BNC CONNECTOR - not shown.

This BNC connector is only provided on the DAD860A

model and is located just above the LOCK LED.

RMM12 INSTALLATION OF DAD860 AND DAD860A

The DAD860A draws additional current from the power

supply compared to the DAD860 model. Thus when

the DAD860A is paired with VMM series agile modu-

lators, one less DAD860A/VMM pair can be used

compared to use with the VMM600 or VMM860 fixed

modulators. Example useable combinations are:

10 DAD860A + 1 PSM121 + 2 open spaces

6 DAD860A + 6 VMM600 + 1 PSM121

5 DAD860A + 5 VMM860AG/AS + 1 PSM121

12 DAD860 + 1 PSM121

6 DAD860 + 6 VMM (fixed or agile) + 1 PSM121

Other combinations are possible. The user must refer

to the specification for each model and make sure

that total load will not exceed the PSM121 rating.

LOCK

LINK

RS232

CONNECTIONS / NOTES

VIDEO OUT

LINK

AUDIO

POWER

RF IN

REAR PANEL CONNECTIONS

R1 - VIDEO OUT - This "F" type connector supplies

the NTSC baseband video output to a modulator or

other suitable device.

R2 - LINK - This receptacle connects to one of the

ten serial cables from the DAD860 CONTROLLER

module for programming the desired parameters

into the DAD860.

R3 - POWER - This receptacle connects to one of

the twelve power cables from the PSM121 power

supply. The cable provides +5V, +12V and GND to

each device to which it is connected.

R4 - RF IN - This "F" type connector attaches to a

CATV (QAM) or off-air (8-VSB) digital TV signal

source.

R5 & R6 - AUDIO L & R - These two RCA Phono

connectors provide left and right stereo audio output

to a modulator or other suitable device.

DAD860 CONTROL MODULE

The DAD860 Control Module may be used to control

either the DAD860 or DAD860A. Models may be

mixed and use a single controller.

The DAD860 Control Module is 2 units wide and thus,

if used, one pair of DAD/VMM must be replaced by

the controller. For example: one could control 10

DAD860 units but only 8 DAD860A units in one

RMM12.

RMM4 INSTALLATION OF DAD860 AND DAD860A

Any combination of DAD860, DAD860A, and VMM

series - either fixed or agile - can be mounted 'on their

side' in the RMM4 rack.