Bosch 6 Series Manuale d'uso e istruzioni per l'installazione - Pagina 13

Stampa la pagina

Bosch 6 Series Manuale d'uso e istruzioni per l'installazione

Round pipes

Use round pipes with an inner diameter of 150 mm (re-

commended) or at least 120 mm.

Flat ducts

Use flat ducts with an inner cross-section that corres-

ponds to the diameter of the round pipes:

¡ Diameter of 150 mm corresponds to ap-

prox. 177 cm².

¡ Diameter of 120 mm corresponds to ap-

prox. 113 cm².

¡ Use sealing strips for different pipe diameters.

¡ Do not use any flat ducts with sharp bends.

12.9 Instructions for the air extraction mode

For air extraction mode, a one-way flap should be in-

stalled.

Notes

¡ If a one-way flap is not included with the appliance,

one can be ordered from a specialist retailer.

¡ If the exhaust air is conveyed through the external

wall, a telescopic duct should be used.

12.10 Information about circulating-air

mode

The appliance must only be operated when it is se-

curely installed and the pipework is connected.

12.11 Installation

Checking the unit

Check whether the fitted unit is level and has suffi-

cient load-bearing capacity.

The max. weight of the appliance is 10 kg.

Note: Note the furniture manufacturer's specifica-

tions with regard to the load-bearing capacity of the

fitted unit.

Ensure that the fitted unit is heat-resistant up to

90 °C.

Ensure that the fitted unit is still stable after the cut-

outs have been made.

Preparing the units

Requirement: The unit is suitable for the installation.

→ "Checking the unit", Page 13

Make the cut-out for the appliance.

Make the cut-out for the exhaust air pipe either

above the fitted unit or behind the fitted unit.

Preparing the appliance

Fit the one-way flaps on the air outlet and click them

into place.

Open the filter cover.

Grasp the front corners of the filter cover and

‒

pull it down in a single, swift motion.

Installation instructions en