Bosch 8 Series Manuale di istruzioni per l'installazione e l'uso - Pagina 7

Stampa la pagina

Bosch 8 Series Manuale di istruzioni per l'installazione e l'uso

Control panel model 2

Explanation

Fan on/off

Automatic mode

1-3

Fan settings

Intensive setting 1

Intensive setting 2

Fan run-on

Metal grease filter saturation indicator

Activated charcoal filter saturation indicator

Light on/off/dimming

Setting the fan

Switching on

Pull out the filter pull-out and touch the

■

The fan will start at setting 2.

Select the fan settings.

■

When the filter pull-out is pushed in, only fan

Note:

settings 1, 2 and 3 can be selected.

Switching off

Touch the

symbol. Slide in the filter pull-out.

Intensive setting

You can use the intensive setting if there is a large

build-up of odours and fumes/vapours.

Touch the

After approximately six minutes, the electronics

automatically reduce the fan to a lower setting . If you

want to end the intensive setting before the preset time

expires, touch the symbol for the required fan setting.

Fan run-on time

Touch the

symbol or slide in the filter pull-out while

the extractor hood is operating.

After approximately 10 minutes, the fan will switch off

automatically.

symbol.

Automatic mode

Switching on

Touch the

symbol.

■

The fan starts at setting 2.

Touch the

symbol.

■

The optimum fan setting 1, 2 or 3 is automatically

set via a sensor.

Switching off

Touch

or any fan setting to switch off automatic

mode.

The fan switches off automatically if the sensor no

longer detects a change in the air quality of the room.

Automatic mode can run for a maximum of four hours.

Sensor control

In automatic mode, a sensor on the extractor hood

detects the intensity of the kitchen steam. Depending

on the sensor setting, the extractor hood automatically

switches to another fan setting.

Default setting: Setting

Lowest setting: Setting

Highest setting: Setting

If the sensor control responds too quickly or too slowly,

it can be changed accordingly:

Press and hold the

the fan is switched off. The setting is displayed.

The sensor control setting can be changed by

touching symbol 1, 2, 3, or the

symbol.

To confirm the entries, press and hold the

for four seconds.

Operating the appliance en

(fan setting 3)

„

(fan setting 1)

‚

†

(fan setting

)

symbol for four seconds when

symbol