Draper 197032EC Istruzioni - Pagina 2
Sfoglia online o scarica il pdf Istruzioni per Schermo di proiezione Draper 197032EC. Draper 197032EC 4. Manually-operated ceiling-recessed projection screen
Stampa la pagina
Access M
Section 1 - Hanging Screen
Please Note: The following steps only apply when
changing or installing the roller. Product ships with Roller
and fabric already in place.
Please Note: When locating viewing surface and checking
clearance for screen operation, ensure that surface is
centered in the case.
HOISTING
BRACKET
CASE
MOUNTING
BRACKET
TYPICAL
INSTALLATION
With typical installation, brackets
may be angled to meet installation requirements.
1. Engage each case mounting bracket
with top of housing and tighten set screws.
2. Screen should be sufficiently supported to withstand
vibration.
Please Note: A hoisting bracket is included on each end of
the case to aid in overhead installation.
3. Ensure that fasteners are of adequate strength and
suitable for the mounting surface chosen. Supporting
hardware such as chains, cables, two 3/ 8 "
etc., must be precisely vertical.
4. Entire bottom of case must be readily accessible after
installation is complete.
5. Front, back, and top of case must be straight—not
forced to warp or bow.
CAUTION: Screen case and flange are not designed to
serve as ceiling support.
6. Do not seal unit in ceiling until screen operates
successfully.
Please Note: If case is painted on location, removal of
roller/fabric assembly is recommended prior to painting.
If not removed, slot on bottom of case should be shielded
to protect viewing surface from paint splatters/overspray.
ALTERNATE
INSTALLATION
Additional set of brackets
required, but NOT included.
Section 2 - Bottom Access Panel Installation/Removal
Bottom access panel secures to the
screen housing with two screws
on each end)
position by engagement brackets with
ball detents that snap into case support
brackets.
(attached to case)
rods,
(9.5 mm)
Access Panel Support Bracket
CASE
MOUNTING
BRACKETS
(one
, and is held in the closed
ALTERNATE
INSTALLATION
Additional set of brackets
required, but NOT included.
2.
Access panel
will hinge down.
2.
Rotate bracket
clockwise to lock
bracket in place.
page 2 of 4
CASE
MOUNTING
BRACKETS
1.
Remove screws
from both ends
of Housing.
1.
Attaching Brackets:
Insert pin in top slot
and push up.
Please Note: There are 2 pins and
the slots are 90°, which requires
the bracket to be inserted, then
rotated slightly
3.
Bracket With Ball Detent:
Engages with Access Panel
Support Bracket.
CAUTION:
Beware of
pinch points at
ends of closure.