Bosch Nexxt washer Operating Manuale di istruzioni per l'uso, la cura e l'installazione - Pagina 8
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso, la cura e l'installazione per Lavatrice Bosch Nexxt washer Operating. Bosch Nexxt washer Operating 26.
Anche per Bosch Nexxt washer Operating: Manuale di istruzioni per l'uso, la cura e l'installazione (37 pagine), Manuale di istruzioni per l'uso, la cura e l'installazione (27 pagine)
Stampa la pagina
Electrical connection
d
WARNING
Power cord must be connected
by a qualified person only.
Connect to individual Brunch
Circuit.
Do not use an adapter.
Do not use an extension cord.
Do not remove ground prong.
For CANADA
Your dryer comes with a power
supply cord, CSA listed in Canada.
The Bosch dryer requires a 4 wire
receptacle.
When installing the receptacle for
the dryer cord, ensure that the
power supply cord is accessible
when the dryer is in the installed
position.
The power cord should only be
replaced by a qualified person.
Use a 4 wire power supply cord
(see electrical connection U.S.A.
below).
For U.S.A.
Your dryer comes without a power
supply cord. The power cord must
meet the following requirements:
-
UL listed in the USA
-
208 240 volt rated (minimum)
-
30 amps
-
Type SRDT or DRT (UL 2158)
-
Five feet long (minimum)
8
d
WARNING
Power cord must be connected
d
by a licensed electrician only.
Use only a U.L. approved
30 amp power cord with strain
relief clamp -
note manufacturer's instructions.
Do not plug end of power cord
into a live receptacle before con
necting power cord to appliance
terminals and closing junction/
splitter box as described below.
Do not reuse old power cord.
Cord must have closed loop or
upturned end wire terminating
connectors.
Do not make a sharp bend or
crimp wiring/conductor at con
nections.
Only a 4 conductor cord shall
be used when the appliance is
installed in a mobile home or an
area where the local codes do
not permit grounding through
the neutral.
Connecting 4 wire power supply
cord
1. Remove the screws from the
cover of the terminal block
located at the top rear of the
appliance.
1 - terminal block
2 - grounding strap
3 - Angle bracket for strain relief clamp
2. Loosen the bottom screw of
the grounding strap. Place the
screw to the GROUND
location. Planish the grounding
strap and hang loosely.
d
3. Fix the strain relief clamp to the
angle bracket. Tighten the nut.
4. Loosen the 2 screws labeled L
and the screw labeled N in the
terminal block. and the screw
of the GROUND terminal.
5. Thread the 4 wire cable through
the U.L. strain relief clamp.
6. Tighten the screws (2.5 Nm) of
the U.L. strain relief clamp so
that the power cord cannot be
moved.
7. Attach the power cord ground
conductor (green) to the
GROUND terminal. Tighten the
screw (2.5 Nm) so that the
ground conductor is held
securely in place.
8. Attach the 2 power cord outer
conductors (red and black) to
1
the 2 terminals labeled L and
the remaining power cord
2
conductor (white) to the
terminal labeled N.
9. Tighten all 3 screws (3 Nm) so
3
that the power conductors are
held securely in place .