Bosch Vision 800 Series Manuale di servizio - Pagina 26
Sfoglia online o scarica il pdf Manuale di servizio per Lavatrice Bosch Vision 800 Series. Bosch Vision 800 Series 43. Gas slide-in ranges
Anche per Bosch Vision 800 Series: Manuale di istruzioni per l'uso (40 pagine), Dimensioni e specifiche (2 pagine), Manuale di installazione (6 pagine), Manuale di istruzioni per l'installazione (28 pagine), Manuale di servizio (36 pagine)
Stampa la pagina
58300000202443_ARA_EN_C
6.7.1
Replacing the Broil Element
1. Remove power to the oven.
2. Detach the element from the reflector.
3. Remove the two screws from the terminal area on the rear
cavity wall.
4. Pull the element forward carefully (there is not much excess
wire) so that the terminal connections move inside the cavity.
5. Disconnect the wires from the terminals, being careful not to
let the harness wires drop back out of reach.
If the wires are too short to disconnect from the front,
continue with step 5.
If the wires were successfully disconnected, skip to step 8.
5. Remove the screws securing the right and left side trim pieces
to the cabinetry.
6. Carefully slide the oven out of the cutout to gain access to the
element terminals from the rear of the unit.
7. Disconnect the wire leads from the terminals.
8. Install the new element.
9. Restore power and test operation.
10. If necessary, slide the oven back into the cutout and reinstall
trim.
6.8
Bake Element
The 240V 2400W bake element is concealed in the base of the oven.
Access to the rear of the unit is necessary when replacing the
element.
Refer to the Element Strip Diagram section to test the bake element at
the control module. A Bake Element Relay Test is also available in
Service mode. See the Service Mode section for additional
information.
If the wires are disconnected from the element terminals, an
ohmmeter can be used to check for resistance of ~24 ohms.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JANUARY 2018
6.8.1
2. Remove the screws securing the right and left side trim pieces
to the cabinetry.
3. Carefully slide the oven out of the cutout to gain access to the
bake element from the rear of the unit.
4. Disconnect the wires from the element terminals.
5. Remove the screws securing the bake element access panel.
6. Bend the access panel downward to expose the element.
7. Holding the terminal plate, pull the bake element outward,
leaving the insulation in place; a putty knife or similar tool may
be useful.
Figure 33 Removing the bake element
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Built-in Wall Ovens
Replacing the Bake Element
Page 26 of 43
800 944-2904