Draper PT142K Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Utensile elettrico Draper PT142K. Draper PT142K 18. 135w 230v with flexible drive shaft
Anche per Draper PT142K: Istruzioni per (18 pagine), Manuale di istruzioni (18 pagine)

Stampa la pagina

BASIC MULTI-TOOL OPERATIONS

8.4 APPLICATIONS:

Your multi-tool can be used for drilling, grinding,

polishing, milling and brushing. Other jobs like

engraving, cutting and removing rust are also possible. It

can be used on most wood, metal, glass and ceramics.

It is a good idea to practice on a scrap piece of material.

Best results are achieved by an even speed and pressure

(not too hard). Use lower speeds for larger tools and

higher speeds for smaller tools.

WARNING: Excessive force on this machine will cause

the motor to overheat and fail. This is not covered by

the guarantee.

8.5 HOLDING THE TOOL - FIGS. 5 - 6

For jobs such as milling or engraving where precision is

required, hold the multi-tool like a pen.

Care should be taken not to fully cover exhaust vents.

Covering the vents will cause the machine to overheat

and fail.

For heavier work like cutting or grinding hold the

multi-tool in the palm of your hand.

8.5 FITTING A CUTTING/SANDING DISC - FIG. 7

With the disc holder

using the plain slot screwdriver (incorporated in the

spanner handle tip). Remove one of the spacing washers

from the end. Insert the screw through the cutting disc,

the washer and secure into the holder (Do not over

tighten).

8.6 FITTING THE SANDING DRUMS - FIG. 8

To fit a drum

, firstly loosen the small screw in the

top of the holder

relax. Slide the sanding drum onto the holder. To secure

simply tighten the screw and the rubber drum will swell,

gripping the drum. (Do not over tighten).

in the chuck, remove the screw

. This will allow the rubber to

FIG.5

FIG.6

FIG.7

FIG.8