Draper 65839 Manuale di istruzioni - Pagina 16

Sfoglia online o scarica il pdf Manuale di istruzioni per Sega Draper 65839. Draper 65839 20. 10"

Stampa la pagina
Draper 65839 Manuale di istruzioni
Trouble
Saw will not start.
Does not make accurate
45° and 90° rip cuts.
Material pinches blade when
ripping.
Material binds on riving
knife.
Saw makes unsatisfactory cuts.
Material kicked back from
blade.
Blade does not raise or tilt
freely.
Blade does not run up to
speed.
Machine vibrates excessively.
Does not make accurate
45°and 90° cross cuts.

TROUBLE SHOOTING

Probable Cause
1. Saw not plugged in.
2. Fuse blown or circuit breaker
tripped.
3. Cable damaged.
1. End stop not adjusted
correctly.
2. Tilt angle pointer not set
accurately.
1. Rip fence not aligned with blade.
2. Warped wood, edge against
fence is not straight.
1. Riving knife not aligned correctly 1. Check and align riving knife with
with blade.
1. Blunt blade.
2. Blade mounted backwards.
3. Gum or pitch on blade.
4. Incorrect blade for work piece.
5. Gum or pitch on table causing
erratic feed.
1. Rip fence out of alignment.
2. Riving knife not aligned with blade. 2. Align riving knife with the blade.
3. Feeding work piece without rip
fence.
4. Riving knife not in place.
5. Dull blade.
6. Letting go of material before it is
past saw blade.
7. Blade angle locking knob not tight. 7. Tighten knob.
1. Sawdust and dirt in raising and
tilting mechanism.
1. Extension cable too light or too
long.
2. Low mains voltage.
1. Saw not mounted securely to
stand or work bench.
2. Stand or bench on uneven floor.
3. Damaged saw blade.
1. Mitre gauge out of adjustment.
Remedy
1. Plug in saw.
2. Replace fuse or reset circuit breaker.
3. Have cable replaced.
1. Check blade with square and adjust
end stop.
2. Check blade with square and adjust
pointer to zero.
1. Check and adjust rip fence.
2. Select another piece of wood.
blade.
1. Re-sharpen or replace blade.
2. Turn blade around.
3. Remove blade and clean with
white spirit and coarse steel wool.
4. Change to correct type of blade.
5. Clean the table.
1. Align rip fence with blade.
3. Install and use the rip fence.
4. Install and use riving knife (with guard).
5. Replace the blade.
6. Push material all the way past saw
blade before releasing the work.
1. Vacuum out loose dust and dirt.
1. Replace with adequate size extension
cable.
2. Check supply voltage.
1. Tighten all fixings.
2. Reposition on flat level surface. Fasten to
floor if necessary.
3. Replace blade.
1. Adjust mitre gauge.
- 15 -