Draper Stormforce 98437 Manuale - Pagina 14

Sfoglia online o scarica il pdf Manuale per Smerigliatrice Draper Stormforce 98437. Draper Stormforce 98437 20. Angle grinder/cut-off tool

Draper Stormforce 98437 Manuale
8.
PREPARING THE ANGLE GRINDER
8.2
MOUNTING CUTTING DISCS –
FIGS.2 – 4
– Press and hold the spindle lock button (7).
– Loosen the locking flange (6) anti-clockwise
using the hex. key (8) supplied.
– The spindle may rotate slightly before the
spindle lock fully engages.
– Remove the locking flange only.
– Clean the flanges and spindle prior to fitting any
accessory.
– Securely tighten the locking flange clockwise
using the hex. key (8) while holding down the
spindle lock button (7).
Note: When using wire cup brushes the locking
flange is not required due to the design of the
brushes. When fitted check the accessory is
correct and, importantly fully secure on the spindle.
Warning! Never press the spindle lock button (3)
while the spindle is in motion.
8.3
BATTERY PACK – FIG.5
Note: This power product is supplied "bare",
without battery pack or charger. Draper 10.8V
multi-tool interchange battery packs and
chargers are available separately through all
local Draper Tools stockists.
Important: Only Draper 10.8V designated battery
packs and chargers can be used in conjunction
with this product. Use of any other third party
battery packs/chargers with this product is
considered misuse and will invalidate the product's
warranty.
(6)
FIG.
1
FIG.
2
(8)
FIG.
3
FIG.
4
– 14 –
– 14 –
(7)