➀ Inspect all boxes to make sure you have received the proper shades & parts.
➁ Open cartons lengthwise.
➂ All brackets, fascia, headboxes, pockets, wall clips, and other hardware must be
installed level. Shades must be level and square.
➃ Please follow installation guidelines carefully. Failure to do so invalidates warranty.
Mounting Brackets or Endcaps
➀ Mark wall, jamb or ceiling for placement of mounting brackets.
➁ Drill small starter hole (if necessary) in mounting surface.
➂ Mount brackets using appropriate fasteners for surface (see Fig. 1 for bracket/
endcap types).
Spring Roller Brackets/Endcaps
Inside
Outside
Ceiling
Left
Bead Chain Brackets/Endcaps
Left and right, ceiling, wall, and jamb
Left
Right
Idler End
Crank Endcaps
Left
Right
Idler End
Shade Installation
Note: See Figure 3 below for specifi c operators.
➀ Place operator end onto its bracket.
➁ For bead chain, place spring-loaded pin into bracket, carefully depress pin by push-
ing the shade roller toward left bracket, slip notches on operator end into right
bracket, then press down to lock in place. Be sure chain loops through two endcap
slots closest to the wall. For cranks, place operator end fi rst, then slide notched pin
Copyright © 2006 Draper Inc.
Installation Instructions
Manual FlexShades by Draper
Caution
Inside
Outside
Right
Optional Bracket Covers (1
Left
Right
Clutch End
Left
Right
Operator End
Figure 1
Form ManualFlexShade_Inst06-R2
end into slot. For spring roller, place right (pin) end into bracket, then rotate spear
end into left bracket.
➂ If #8 clutch is provided, attach snap-on cover to back plate of chain guide using
screw (provided) in back hole (see Fig. 2). If #16 clutch is provided, use only back
plate portion of chain guide.
Ceiling
Left
5
/
" only)
8
Idler End
Stop Balls
Use stop balls provided
by Draper. Stop balls by
others may be too small,
and become lodged in the
clutch mechanism.
Idler End
➃ Set upper and lower travel limits by installing stop balls to bead chain (crimp closed
using pliers) (see Fig. 3 above). Be sure to use the stop balls provided in hard-
ware packet by Draper. Stop balls by others may be too small, and become
lodged in the clutch mechanism.
Please Note: If shade fabric is uneven, see "Troubleshooting" on page 2.
➄ For endcaps, snap end covers into place (see Fig. 4).
Print ed in U.S.A.
Figure 2
Spring Roller
Bead Chain Clutch
Crank
Please Note:
Crank operated FlexShades do
not have stops; if crank oper-
ated FlexShades are lowered
too far, fabric can come loose
from the roller.
Figure 3
Figure 4
(Continued on back page)
Right
Operator End
Operator End
Stampa la pagina