Bottom-Up FlexShade
Small and Large Hardware
Section 4 - Shade Fabric
Top Roller Mounting
Caution: Do not allow shade roller to become
exposed by running shade fabric too far down. Be
sure to use stop balls provided in hardware packet
by Draper
to set up and down travel limits. Stop
®
balls by others may be too small, and become
lodged in clutch mechanism.
Please Note: If shade fabric is uneven, see "Field
Adjustments" on page 2.
Figure 4-A
1.
Carefully work
open (clutch) end
of roller onto
bead chain clutch.
!
Tube indentation
must be aligned
with the FLAT side
of the clutch sprocket.
Figure 4-B
2.
Figure 4-C
3.
Test shade to
ensure that
roller is level
and operating
properly.
4.
If not, adjust idler
leveling screw with
3mm Hex Wrench,
available upon
request when ordering shade.
NEXD,
®
Section 5 - Top Roller Spring Assist Option
1. Remove the safety screw and slide from the top idler endcap. Retain these pieces for later
2. Install the Top Roller Assembly:
Fig. 6-B:
necessary to compress the spring-loaded spear.
Caution: The retaining clip must be installed around the idler-end shaft as shown to prevent the
roller assembly from moving left or right during operation, and to ensure that the spring-loaded
shaft does not retract into the mechanism in case of a bearing failure.
3. Replace Slide and Safety Screw. Place into groove at an angle, slide up, and make sure the bottom
of the slide is hooked into the Receiver
Caution: If Spring Assist is provided with this unit, pre-tension the Spring Assist by using the bead
chain to add pre-rotations to the top roller. Refer to specific information provided on shade
fabric ticket for the number of pre-rotations required.
Figure 5
Slide idler end
pin up through
one of the slots
on idler endcap,
and into seat
for pin.
:
NOTE
See illustration
Figure 6-A
for different
path options.
Install tube onto clutch.
Fig. 6-A:
Swing the idler end into place, then slide the idler end spear into the receiver. It may be
(Fig. 5, reverse order)
1.
!
Tube indentation
must be aligned
with the FLAT side
of the clutch sprocket.
Figure 6-B
page 4 of 8
.
2.
Slide
(RETAIN
FOR
Safety Screw
LATER)
(RETAIN FOR LATER)
Note: Retainer Clip
has extrusion to fit
into slots on shaft.
.
(Fig. 5)
Stampa la pagina