Clutch-Operated FlexShade
Small and Large Hardware
PLEASE READ - Important Installation Information
Caution:
1. Inspect all boxes to make sure you have
received the proper shades and parts.
Controls may be shipped separately, or in
same carton as shades.
2. Open cartons lengthwise, taking care not
to cut into cardboard shipping container.
Section 1 - FlexShade NEXD Mounting With Endcap
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
Figure 1
Wall Mounting Endcap
1. Mark wall for placement of endcaps.
2. Drill small starter hole
(if necessary)
3. Attach idler and operator endcap covers to endcaps.
4. Mount endcaps using appropriate fasteners for surface.
Figure 2
Ceiling Mounting Endcap
1. Mark ceiling for placement of endcaps.
2. Drill small starter hole
(if necessary)
3. Attach idler and operator endcap covers to endcaps.
4. Mount endcaps using appropriate fasteners for surface.
Figure 3
Jamb Mounting Endcap
Please Note: Safety Bracket
(s)
at this time when Jamb Mounting.
1. Mark wall for placement of endcaps.
2. Drill small starter hole
(if necessary)
mounting surface.
3. Attach idler and operator endcap covers
to endcaps.
4. Mount endcaps using appropriate fasteners
for surface.
Please Note: If endcaps are included in the order,
drill through the endcap cover and secure with the endcap.
®
3. Before mounting shades, verify measurements
on label provided with shade, and ensure unit
is installed at correct width.
4. All endcaps, fascia, pocket headbox, and
other hardware must be installed level.
Shades must be level and square.
in mounting surface.
in mounting surface.
1.
Push endcap
covers onto
MUST be installed
both endcaps.
.
(Section 6, P.6)
in
NEXD,
1.
Push endcap
covers onto
both endcaps.
1.
Push endcap
covers onto
both endcaps.
6. Read the following installation guidelines
thoroughly and follow them carefully.
Failure to do so may cause product to fall or
otherwise fail, and invalidates warranty.
7. Installer is responsible for selecting mounting
hardware appropriate for site conditions.
2.
Mount
endcaps
to wall.
2.
Mount endcaps
to jamb.
page 3 of 8
2.
Mount
endcaps
to ceiling.
PLEASE NOTE:
If endcaps are
included in order,
drill through endcap
cover and secure
with endcap.
Endcap requires
a minimum of
two fasteners.
It is not necessary
to utilize all four
corners.
Stampa la pagina