Draper 53016 Manuale di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per Sander Draper 53016. Draper 53016 16. 230v 1200w angle polisher

Stampa la pagina
Draper 53016 Manuale di istruzioni
5.
HEALTH & SAFETY INFORMATION

5.2 CONNECTION TO THE POWER SUPPLY

To eliminate the possibility of an electric shock your machine has been fitted with a BS
approved, non rewireable moulded plug and cable which incorporates a fuse, the value of
which is indicated on the pin face of the plug. If the plug is marked with the
and the fuse needs replacing, an
rating. If the plug is not
and
BS Kitemark, of the same amp rating should be used.
The fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse
cover is required, ensure it is the same colour as that visible on the pin face of the plug (i.e.
red). Fuse covers are available from your Draper Tools stockist.
If the fitted plug is not suitable, it should be cut off and destroyed. *The end of the cable
should now be suitably prepared and the correct type of plug fitted. See below.
*WARNING:
A plug with bare flexible wires exposed is hazardous if engaged in a live power socket outlet.
WARNING: THIS APPLIANCE IS DOUBLE INSULATED.
The mains lead is coloured Blue - Neutral, Brown - Live.
As these colours may not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the
letter 'N' or coloured black or blue.
The wire which is coloured brown must be connected to the terminal which is marked with
the letter 'L' or coloured red or brown.
EXTENSION LEAD CHART:
Extension lead sizes shown assure a voltage drop of not more than 5% at rated load of tool.
Ampere rating
(on Name plate)
Extension cable length (Metres)
7.5
15
22.5
30
40
IMPORTANT:
On products exceeding 2000W it is recommended that the power cable and/or extension
cable are fully unwound before a connection is made to the power supply. However, ensure
the residual cable does not pose a trip hazard.
For safe operation of this appliance it should be supplied via a residual current device (RCD)
with tripping current of no more than 30mA.
8
approved BS1362 fuse must be used of the same amp
marked, a fuse with the
3
0.75
0.75
0.75
0.75
0.75
symbol,
BS Kitemark, or both
6
10
Wire Size mm
2
0.75
1.0
0.75
1.0
0.75
1.0
0.75
1.25
0.75
1.5
symbol
13
1.25
1.5
1.5
1.5
2.5