Draper 65084 Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Sander Draper 65084. Draper 65084 16. Dual action air composite sander
Anche per Draper 65084: Manuale di istruzioni originale (20 pagine)

Stampa la pagina

AIR SUPPLY

8.1

AIR TOOL OIL SPECIFICATION

Failure to follow these instructions will lead to premature malfunction of the equipment which is not

covered by the guarantee.

Air tool oil viscosity refers to it's properties to flow and how it reacts with heat. A low viscosity is

thinner than a high viscosity.

Air tool oil becomes thinner as it heats so choosing the right viscosity is essential. If the viscosity is

too low it may provide insufficient lubrication when heated. Equally, if it is too high, the fluid may

provide excessive resistance to move through the lines when cold.

The ISO (International Standards Organisation) viscosity grading system measures the kinematic

viscosity in centistokes (cSt) at 40º which is today's accepted standard. The SAE (Society of

Automotive Engineers) viscosity grade value is based on a scale.

This equipment is suited to an ISO grade 22 – 32 (SAE grade 5W – 15W) monograde oil.

The oil must be constantly supplied to the equipment during use to ensure complete lubrication

and optimum performance is achieved. It also acts as a rust inhibitor when the equipment is not in

use. We recommend the use of Draper Air Tool Oil.

This air tool operates at a maximum pressure of 90psi and must be controlled via a combination

pressure regulator, in-line lubricator and moisture filter such as the Draper range (see you local

Draper stockist) which with proper maintenance will ensure a constant supply of dry air and

lubricating oil at all times (see illustration below). Always check machine operating pressure before

use.

Water in the compressor tank will cause serious corrosion to your air tools and should be drained

daily to avoid excessive water in your air supply. Dirty wet air rapidly shortens the life of your air

tool.

If you are using an air tool on a hose over 25ft long it is advisable to increase the bore of the hose

to the next larger size available, i.e.,

volume of air to power the machine.

8.2

RECOMMENDED AIR SUPPLY SET UP – FIG. 1

FIG.1

After each use and before prolonged storage, lubricate the equipment with approximately 1.5ml of

air tool oil directly down the air inlet.

⁄

" increases

⁄

". This will ensure adequate pressure and

– 11 –