Draw P25 Manuale

Sfoglia online o scarica il pdf Manuale per Bilance Draw P25. Draw P25 2.

Stampa la pagina

1- SAFETY TECNOLOGY

One of the main objectives of the companies is the reduction of production costs and at the same

time to increase productivity. In this context, the ergonomics in the workstation is of importance

maximum. The Draw™ Retractors Balancers provide safety and convenience in the production

and assembly systems. Your constructive manner make them safe and durable as well as an

indispensable item in the workbenches and assembly lines.

2- INSTALLATION MODE

Hang the balancer by swivel hook assembled on its top. The balancer should be placed directly

over the work area. Your assembly must be done in such a way that minimizes the contact of the

cable in the cable guide, in other words, perpendicularly. To prevent the fall/dropping of the

balancer, install and secure, as indicated in the figure, a safety chain. The length of the safety

chain should be the lowest possible, preventing that in case of rupture of the hook of sustaining

the balancer does not fall more than 150 to 300 mm.

CORRECT

Keep the load hanging

Perpendicularly.

The fitting with trolley allows a better operation of the balancer and allows a greater area of

coverage.

A- The Draw™ Balancers models P15 to P30 leave factory with steel

cable of the 1,8m useful and 0,5m additional cable that is outside the

body of the balancer which may be increased, if the user want, rising the

cable gland (never down the cable gland because the cable will be loose

and may overlap, locking the balancer).

B- All Draw™ Balancers is factory preset to the specified mid-range

load. Ex: a balancer model P-15 has specified, on the label, the capacity

from 11 to 18 kg and leaves factory preset to load of 15 kg.

C- To reload the balancer and adapt it to the workload, turn clockwise

the hex nut (item 37) using a 5/8 (16 mm) wrench. To download, turn

counter-clockwise the same nut (see figure B).

download the balancer with the load hang down on the cable.

D- The balancer has on the back a handle (item 45) that locks the reel in

6 (six) positions at each turn. In this way, it is possible to handle the load

without any effort from the operator (see figure B).

READ CAREFULY THIS MANUAL BEFORE THE INSTALLATION

Fig. A

INSTRUCTION MANUAL

P15 from 11 to 18kg

P20 from 17 to 18kg

INCORRECT

Working with the inclined

load causes premature wear

of the cable and the reel and

excessive effort from the

operator.

Attention: Never

P25 from 22 to 28kg

P30 from 27 to 34kg