Drawmer D-Clock-R DMS-6 Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Drawmer D-Clock-R DMS-6. Drawmer D-Clock-R DMS-6 9. Dual redundant word clock distribution amplifier
Stampa la pagina9
4x Front Panel Outputs:
1
4x BNC output connectors mounted
on the front for ease of connectivity.
Clock Present LED's:
4
Show the presence of Word Clock
and AES3id for both SYNC1 and
SYNC2 inputs 7
2x Auto Sensing Word-Clock/
7
AES3id Inputs:
2 Dual Redundant BNC Word Clock
/ AES3id inputs can be connected
simultaneously to provide a clock
and also a backup, should one fail.
The input selection is carried out
automatically by the DMS-6, with
SYNC 1 being default and SYNC 2
auxiliary.
The DMS-6 D-Clock-R is designed for standard 19" rack
mounting and occupies 1U of rack space. Avoid mounting
the unit directly above power amplifiers or power supplies
that radiate significant amounts of heat.
If the unit is to be used in a mobile situation, it is strongly
The DMS-6 D-Clock-R is fitted with two identical and
independent power supply units, providing Dual
Redundancy. Either can be used solely to supply power
to the unit, but in situations where it is critical that power
must be maintained mains power should be supplied to
both units. With both power supplies receiving power the
units will share the load, however, should either fail, the
other is capable of fully driving the unit.
The unit will be supplied with two power cables
suitable for domestic power outlets in your country.
For your own safety it is important that you use
these cables. The unit should always be connected
to the mains supply earth using at least one of these
cables.
FEATURES OVERLAY
1
Display:
2
Blue/White liquid crystal display
with three switchable modes of
operation.
Active Input LED's:
5
Two led's showing which of the two
word clock inputs 7 has been
automatically selected.
12x BNC Clock Outputs:
8
Buffered BNC wordclock outputs with
33 Ohms impedance.
INSTALLATION
POWER CONNECTION
2
3
8
3
Active PSU LED's:
6
Two led's showing which of the two
PSU inputs 9 is operational.
9
recommended that the rear of the unit is supported in the
carrying rack to avoid bending the front panel rack mounting
'ears'. Use fibre or plastic washers to prevent the front panel
becoming marked by the mounting bolts.
Always connect the mains earth to the unit.
Powered by dual universal switch mode power supplies,
the DMS-6 D-Clock-R operates from mains voltages
between 85 - 250v, eliminating the need to make any
changes when touring and allowing the unit to remain fully
operational during large fluctuations in the mains power
supply.
4
5
6
7
Display Mode:
Switch to control the mode of
display 2
between Frequency,
PPM and %.
Dual Redundant PSU Inputs:
2 x identical power supplies can be
used either simultaneously or
independently, should power to one
fail.
5