Bosch Benchmark HBLP451LUC Manuale di servizio - Pagina 28
Sfoglia online o scarica il pdf Manuale di servizio per Forno Bosch Benchmark HBLP451LUC. Bosch Benchmark HBLP451LUC 45. Built-in wall ovens
Anche per Bosch Benchmark HBLP451LUC: Specifiche tecniche (3 pagine), Manuale di installazione (39 pagine), Manuale di installazione (22 pagine)
Stampa la pagina
58300000181895 ARA EN A
5. Support the lens and repeat step 4 with the second clip; carefully
slide the lens out and set aside; do not force the lens out – it
should detach easily.
6. Pull the halogen bulb from its socket; if it is difficult to grasp the
bulb using one hand, use both forefingers to pinch behind the
rounded part of the bulb, then pull the bulb out using both hands.
NOTICE
Any surface contamination from the oil of fingers or hands can cause
damage to halogen bulbs and premature failure. Direct contact with
the bulb should be avoided. Always hold a halogen bulb with a dry
cloth or clean paper towel.
7. Grasp the new bulb with a clean, dry cloth. Align the bulb prongs
with the socket holes and press into place.
Figure 41 Insert the prongs on the new halogen bulb into the holes in the socket
8. Reinstall the glass lens cover by inserting it into the mounting clips
and gently pressing the end of each clip until it snaps in place and
secures the lens.
9. Restore power to the oven and test operation.
6.6.2
Replacing the Lamp Receptacle Assembly
The lamp receptacle assembly service part includes the receptacle,
glass lens and halogen bulb.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
1. Turn off power to the oven at the main power supply (fuse box or
breaker box).
2. Remove oven racks to provide access to the light lens and
halogen bulb.
3. Optional: on ovens with bottom-hinge doors, the door may be
removed to provide easier access and visibility.
4. Remove the screw securing the receptacle to the cavity side wall.
Figure 42 Removing the light receptacle
5. Carefully pull the receptacle away from the cavity wall, until the
wire plug can be disconnected from the main harness; be careful
not to drop the main harness wires.
Figure 43 Lamp receptacle assembly
6. Install the new lamp receptacle.
7. Restore power and test operation.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Page 28 of 45
800 944-2904