Bosch Benchmark Series Manuale di servizio - Pagina 17
Sfoglia online o scarica il pdf Manuale di servizio per Forno Bosch Benchmark Series. Bosch Benchmark Series 45. Built-in wall ovens
Anche per Bosch Benchmark Series: Manuale di servizio (36 pagine), Manuale di installazione (32 pagine), Manuale di riferimento rapido (4 pagine), Manuale di istruzioni per l'installazione (40 pagine), Manuale di avvio rapido e di sicurezza (13 pagine)
Stampa la pagina
58300000181895 ARA EN A
3. Partially close the oven door until it is open about 7" and catches
on the hinge-stop levers.
4. Using both hands, lift door upward and outward to disengage the
hinges from the hinge receiver slots.
5. Set the door aside on a protected flat surface.
To reinstall the door...
1. Hold the door firmly in both hands and position the hinges in the
hinge receivers, so that the slot in the base of the hinge (A)
engages with the hinge receiver (B).
Figure 11 Position the hinge in the hinge slot
2. Tilt the door inward and slide the hinges into place; the hinges
should catch and the door should remain in place.
3. Open door fully to expose the hinge levers and hinge receiver
slots.
4. Flip the right and left hinge levers forward until they are fully
closed.
Figure 12 Closing hinge lever
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
5. Open and close the door carefully to confirm that the door is
installed correctly and securely, and does not appear to be askew
when closed.
6. Carefully close and open door several times to check operation.
6.1.2
The doors on Bosch Benchmark series ovens are soft-close, and
operate using one dampen hinge and one spring hinge. The hinges
are offered in service kits which include both the RH and LH hinges;
always replace hinges in pairs.
NOTICE
The dampen hinge has a cylinder inside which holds oil that acts as
the dampening fluid and causes the soft-close effect. The oil must be
in the bottom of the cylinder. If the door does not close softly, allow
the hinge time to recover in the vertical position (door closed) for 15-
30 minutes, then re-test door operation. See bulletin packed with
hinge kits for more information.
To access the hinges...
1. Remove the door as described in the Removing and Reinstalling
the Door section.
2. With the porcelain-coated door liner up, remove the two screws on
each side of the door liner.
3. Remove the screws along the bottom of the door assembly.
Figure 13 Removing door liner screws
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Replacing the Hinges
Page 17 of 45
800 944-2904